Description
Steering column stalk switches COM 2000 for Citroën and Peugeot vehicles. They control fog lights, ESP, front and rear wipers, headlights, indicators, horn, cruise control and car radio.
Product Overview
High-quality COM 2000 steering column stalk assembly designed for a wide range of Citroën and Peugeot models. This multifunction stalk operates lighting, indicators, front and rear wipers, fog lamps, ESP interactions, horn, cruise control and radio controls. Ideal for professional workshops and experienced DIY mechanics looking for a direct replacement part. Commonly searched under part code 96542560XT and related reference numbers listed below, making it easier to find the correct unit for repair or maintenance.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën Berlingo II, Citroën C5 I, Citroën C8, Citroën Xsara Picasso, Peugeot 206, Peugeot 307 I, Peugeot 406, Peugeot 807, Peugeot Partner II
- Product Codes: 96542560XT
- Additional Numbers: 6242C6, 6239Y5, 6239M6, 6239QA, 6239T6, 6239W5, 6239X5, 6239Y9, 624220, 6239P0, 6239Y0
Function and Benefits
The COM 2000 steering stalk is a central control interface on the steering column that consolidates multiple vehicle functions into ergonomic levers. Replacing a worn or faulty stalk restores reliable signaling, lighting control, wiper operation and cruise control engagement. For garages, the unit simplifies troubleshooting by targeting a single replaceable component when multiple driver controls malfunction.
How To Replace
Basic replacement steps for experienced technicians and competent DIYers:
- Safety First: Disconnect the vehicle battery and wait at least 10 minutes to allow any residual charge in the airbag system to dissipate. Follow the manufacturer safety procedures.
- Remove Steering Column Trim: Use trim tools and appropriate screwdrivers or Torx bits to open the upper and lower steering column covers.
- Disconnect Connectors: Unplug electrical connectors from the stalk assembly. Take care with locking tabs to avoid damage.
- Unclip And Remove Stalk: Release retaining clips or fasteners and remove the old stalk assembly from the column.
- Fit New Unit: Install the replacement stalk, secure fasteners, and reconnect all electrical plugs firmly.
- Reassemble And Test: Refit steering column covers, reconnect the battery, and test all functions including indicators, lights, wipers, horn, cruise control and radio buttons before road use.
Mounting Recommendations
Always follow the vehicle manufacturer repair manual. Use plastic trim tools to avoid scratching covers and the correct Torx or screwdriver sizes for fasteners. Ensure connectors are clean and fully seated; corroded pins should be cleaned or replaced. After installation confirm that all functions work in both ignition and driving conditions. If any safety system warnings appear on the dashboard after fitting, recheck connections and fuses and consult the workshop manual.
Why The Part Fails
Common failure causes include mechanical wear of plastic components and internal springs, contamination and moisture leading to corrosion of electrical contacts, accumulation of dirt and grime, and accidental damage from excessive force. Frequent use of stalk-operated systems such as wipers and indicators accelerates wear. Electrical faults in the wiring harness or blown fuses can mimic stalk failure, so verify related circuits during diagnosis.
Notes For Professionals
This part is widely used across multiple Citroën and Peugeot models and is often located by the product code 96542560XT or the alternative reference numbers listed in the technical information. When diagnosing, check related fuses, ground connections and connector integrity to avoid replacing the stalk when the root cause lies elsewhere.
