Description
Steering column stalk controllers DELPHI COM 2000 for PEUGEOT 206. Multifunction stalk control unit. Controls headlights, fog lights, cruise control and car radio (radio control must be supplied or transferred), front and rear wipers, and the horn.
The Delphi COM 2000 multifunction stalk is a direct-fit style control assembly designed for Peugeot 206 applications. It consolidates lighting, wiper, horn and cruise control commands into a single steering-column-mounted module, simplifying cabling and restoring factory functionality. Ideal for professional workshops and experienced DIYers who service Peugeot electrical and steering-column systems.
Features And Benefits
- Multifunction Design: Integrates headlight, fog light, cruise control and radio switching with front/rear wiper and horn control.
- OEM-Style Fitment: Matches original Delphi COM 2000 architecture used on Peugeot 206, enabling straightforward mechanical replacement.
- Durable Construction: Designed for repeated stalk actuation and to house microswitches used by factory systems.
- Part-Number Search Friendly: Commonly sought under OEM numbers (see Technical Information), making it easy to locate by part code.
Technical information
- Manufacturer: Stellantis / Delphi
- Model: Peugeot 206
- Product Codes: 96595073XT, 96511181XT, 96477524XT, 96533567XT, 96446871ZL, 96605637XT, 6242E9, 6239Y3, 624265
- Additional Numbers: 6242000000000, 6239Y3, 624265, 96446871ZL
Replacement Procedure (Overview)
Work should be carried out by a qualified technician or a competent DIYer familiar with steering-column work and airbag safety. Basic steps:
- Disconnect the negative battery terminal and wait the manufacturer-recommended time to disable the airbag system.
- Remove the steering wheel trim and upper/lower column shrouds to access the stalk assembly.
- Unplug the electrical connectors and note/label connector positions for reassembly.
- Remove the retaining screws/clips and withdraw the old stalk module from the column.
- Fit the replacement unit, reconnect connectors, reassemble the shrouds and restore the battery connection.
Installation Recommendations
- Always isolate the battery before starting work to avoid airbag deployment and to protect vehicle electronics.
- Use the correct Torx/screwdriver sizes and avoid over-tightening plastic fasteners.
- Check connector contacts for corrosion and ensure secure, fully seated plugs to prevent intermittent faults.
- If cruise or radio functions require a separate control pad, transfer the original control or fit the required module as noted in the product description.
- After installation, verify all functions (lights, fogs, wipers, horn, cruise) on the vehicle before road use.
Common Failure Causes
- Wear Of Internal Contacts: Frequent use of stalks causes microswitch and contact wear, leading to intermittent or non-functional switches.
- Moisture Ingress And Corrosion: Water penetration can corrode terminals and switches, especially in older vehicles or where seals are degraded.
- Mechanical Damage: Physical impact or rough handling during previous repairs can crack housings or break mounting tabs.
- Connector Issues: Loose or oxidised connector pins cause signal loss or erratic behavior.
This multifunction stalk is a practical repair solution for restoring original driver controls on Peugeot 206 vehicles. Use the product codes above when searching or ordering to ensure correct fitment for the specific vehicle.
