Description
Complete front driver’s seat wiring harness for Peugeot 3008 and 5008 First Series.
This high-quality used wiring harness (part number 6545XR) is intended for the front driver’s seat of Peugeot 3008 and Peugeot 5008 First Series vehicles. Designed to restore electrical functions quickly, it helps recover seat adjustment, heating, belt buckle sensing and safety circuits after damage or wear. Ideal for professional workshops and DIY mechanics who frequently search by part number, the harness is a direct-fit replacement that speeds up repair times and reduces troubleshooting.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 3008 I, Peugeot 5008 I
- Product Codes: 6545XR
- Additional Numbers: N/A
Function And Typical Features
The front driver’s seat wiring harness routes power and signals between the vehicle wiring loom and the seat’s electrical components. Typical circuits served include seat adjustment motors, heating elements, seat belt buckle switch, occupancy/weight sensor and side airbag connector where fitted. By replacing a faulty harness you restore reliable electrical connections and safety-related signals that affect airbag deployment logic and seatbelt warning systems.
Replacement Procedure
Basic steps for replacement: disconnect the negative battery terminal before starting to prevent accidental airbag deployment. Remove trim panels and unbolt the seat to gain access. Carefully unplug all seat connectors and release any clips fixing the harness to the seat structure and rails. Install the new harness following the original routing, secure clips and connectors, then refit the seat and torque mounting bolts to manufacturer specification. Reconnect the battery and verify all seat functions and airbag/seatbelt warning lights are normal.
Installation Recommendations
- Always Disconnect The Battery Before Working On Seat Electricals To Avoid Airbag Deployment.
- Inspect Connectors And Pins For Corrosion Or Bent Contacts; Clean Or Replace As Needed.
- Route The Harness Along The Original Path And Secure All Clips To Prevent Chafing At The Seat Rails.
- After Installation, Perform Functional Tests On Seat Adjustment, Heating, Belt Buckle Sensor And Airbag/Occupancy Circuits Where Applicable.
- If Uncertainty Arises With Airbag Or Safety Circuits, Use Diagnostic Equipment Compatible With PSA/Peugeot Systems.
Why This Part Commonly Fails
Seat wiring harnesses typically fail due to repeated flexing and abrasion at the seat rails and pivot points. Over time the constant movement of the seat can break conductor wires, damage insulation or loosen connector contacts. Corrosion from moisture, spilled liquids or poor connector sealing can also cause intermittent faults. Damage can occur during seat removal if connectors are pulled incorrectly or clips are broken.
Notes For Professionals
When repairing or replacing seat harnesses, pay attention to connector pin integrity and any modules mounted in the seat (e.g., occupancy sensors or airbag connectors). Correct routing and secure fixing of the harness will prevent early re-failure. Part number 6545XR is commonly used in parts searches for Peugeot 3008 I and 5008 I seat electrical faults.
