Description
Driver’s window switch for CITROËN C1 and PEUGEOT 107 models from 2010 to 2013.
Product Overview
Direct replacement driver’s power window switch designed for Citroën C1 and Peugeot 107 (2010–2013). Finished in black and referenced under code 6554KZ, this switch restores reliable control of the driver’s window and is a common spare part for front-left door repairs. Clear labeling with the product code (6554KZ) helps technicians and DIYers find the correct unit quickly.
Key Benefits
- Exact Fit For Door Trim: Manufactured to match the original mounting points and connector layout for straightforward installation.
- Reliable Switch Action: Restores smooth up/down operation and window auto functions (if present on vehicle).
- Cost-Effective Repair: Replacing the switch is often quicker and cheaper than troubleshooting multi-component electrical faults.
- Search-Friendly Product Code: 6554KZ included to improve findability in parts searches.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C1, Peugeot 107 (2010–2013)
- Product Codes: 6554KZ
- Other Numbers: Color: Black; Position: Driver’s Door (Front Left)
Function And Typical Faults
The driver’s window switch is the primary user interface for controlling the electric window motor on the front-left door. It completes circuits to raise, lower or stop the window and, in some variants, provides an auto-one-touch function and central locking interlock. Common failure modes include worn electrical contacts, broken plastic actuator parts, water ingress and corrosion, or internal short circuits. Symptoms of a failing switch are intermittent operation, stuck or non-responsive window, or complete loss of control from the driver’s side.
Replacement Procedure (Overview)
Suitable for experienced DIYers and professional technicians. Typical replacement steps:
- Prepare: Park vehicle on level ground, ignition off. It is recommended to disconnect the negative battery terminal before starting work to avoid short circuits.
- Remove Door Trim: Carefully remove screws and plastic clips securing the door trim. Use trim tools to avoid breaking retaining clips.
- Access Switch: Pry out the switch bezel or armrest insert, then unplug the electrical connector(s).
- Swap Unit: Remove retaining screws or clips holding the switch, install the new switch (ensure correct orientation) and reconnect the connector(s).
- Test Operation: Reconnect the battery if disconnected, test all window functions and auto features before final reassembly.
- Reassemble: Refit door trim and fasteners, checking that all clips seat correctly and that the window runs freely.
Installation Recommendations
- Always Disconnect Battery: To prevent electrical damage and accidental shorting, disconnect the negative battery terminal during removal and installation.
- Use Proper Tools: Plastic trim tools reduce the risk of breaking clips and scratching surfaces.
- Inspect Connectors And Wiring: Check for corrosion or damaged wires in the door harness; repairing wiring faults prevents repeated failures.
- Test Before Final Fitment: Verify switch function and window movement fully before snapping trims back into place.
Why This Part Fails Most Often
Wear and contamination are the primary causes of switch failure. Repeated operation causes contact wear and plastic fatigue. Moisture ingress from door seals or window leaks causes corrosion on contacts and connectors. Mechanical damage from improper removal or impact can also break the switch housing. In many cases, replacing the switch resolves symptoms without further electrical diagnosis, but if wiring or motor faults are present, they should be addressed to avoid damaging the new switch.
Compatibility And Search Tips
This switch is commonly searched by code 6554KZ and by vehicle model names Citroën C1 and Peugeot 107 (2010–2013). When ordering, confirm the switch position is the driver’s/front-left unit and that the connector shape matches the vehicle harness to ensure direct fitment.
