Description
Gas potentiometer pedal CITROEN C5 PEUGEOT 407
With cruise control sleeper – kickdown
Tested, all values OK
Accelerator pedal Citroën Peugeot Bosch 9650341780 0280755012 is an electric accelerator pedal with integrated position sensor (potentiometer) and cruise control function. This is an original part intended for Citroën and Peugeot cars, where it ensures accurate gas dosing and safe signal transmission to the engine control unit.
Technical information:
Manufacturer: Bosch
Model: electronic gas pedal with position sensor and kickdown function
Product codes: 9650341780, 0280755012, F00C3E2429
Other numbers: 1601Q4, 1601Q0
Purpose: Citroën C5, Peugeot 407 (depending on the specific engine and year of manufacture)
Features:
– Conversion of pressing the gas pedal into an electrical signal for the ECU
– Integrated sensor for working with cruise control
– Kickdown function – ensures full throttle opening, typically when the pedal is pressed hard
This accelerator pedal is tested and shows the correct values, which is important for smooth acceleration, stable idling and flawless cruise control function. A faulty pedal sensor often causes engine jerking, limited power, hibernation or the engine light to come on, so a quality replacement is essential for reliable car operation.
Thanks to the use of the original electric pedal with the codes 9650341780, 0280755012, F00C3E2429, 1601Q4 and 1601Q0, compatibility with the corresponding versions of Citroën C5 and Peugeot 407, correct cooperation with the control unit and accurate sensing of the pedal position in the entire range are ensured.
Installation recommendations:
– Before disassembling the old pedal, disconnect the battery to avoid damaging the electronics.
– Check the attachment – the pedal must match the type of holder and the position on the body.
– During assembly, be sure to tighten the screws firmly, but without overtightening, so as not to deform the plastic body of the pedal.
– Insert the cable harness socket as far as it will go, check that the connector is clean, free of oxidation and dirt.
– After installation, we recommend initializing / adapting the gas pedal in the control unit using diagnostics, if the specific car model requires it.
– After installation, test smooth operation – check engine response and correct cruise control function by depressing the pedal slowly and quickly.
A properly functioning Bosch gas pedal with the above codes is key to a comfortable and safe drive, precise engine power dosing and reliable cruise control function in Citroën C5 and Peugeot 407 cars.
