Description
Seat Heater Control Switch for Peugeot 307 and 607.
Product Overview
This seat heater control switch is designed for Peugeot models and provides reliable operation for heated seats in workshop and DIY repair scenarios. It is a direct-fit control intended to replace worn or faulty switches in Peugeot 307 and Peugeot 607 vehicles. Commonly searched by part numbers, this unit is an essential spare for garages and technicians dealing with climate comfort systems.
Features and Functionality
- Direct replacement for the original seat heater control switch used on specified Peugeot models.
- Simple interface to switch seat heating on/off and, depending on vehicle equipment, select heating levels.
- Robust construction to withstand repeated mechanical use in daily driving conditions.
- Replaces worn contacts and faulty internal potentiometer or PCB faults that cause intermittent or total loss of seat heating control.
Compatibility and Part Numbers
This part is primarily compatible with:
Technicians and DIY installers often look for the following reference numbers when sourcing this switch.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Peugeot 307; Peugeot 607
- Product Codes: 96296491ZL; 8904TW
- Additional Numbers: NFP (as marked)
Installation Recommendations
- Always follow manufacturer service instructions and safety procedures during removal and installation.
- Disconnect the negative battery terminal before starting work to avoid short circuits and to protect vehicle electronics.
- Remove the seat trim or center console bezel as required to access the switch. Use appropriate trim tools to avoid damaging panels.
- Unplug the electrical connector from the old switch and note connector orientation. Replace the switch and reconnect firmly.
- Test functionality before reassembling trim: verify all heat levels and indicator lights (if equipped) operate correctly.
- Reinstall trim pieces carefully and ensure clips and fasteners are secured to prevent rattles or loose panels.
Most Common Failure Causes
Seat heater switches typically fail due to mechanical wear of internal contacts from frequent use, ingress of moisture or dirt causing corrosion, or internal PCB/potentiometer faults leading to intermittent operation or complete loss of function. Overheating from a faulty seat heating element or poor electrical connections can also accelerate switch deterioration. Regular inspection and secure connector fitment help prolong service life.
Why Choose This Part
For workshops and experienced DIYers, replacing a faulty seat heater switch with a correct-fit unit restores driver comfort and avoids electrical faults that can affect seat heating circuits. Using the correct part number (e.g., 96296491ZL or 8904TW) reduces installation time and ensures compatibility with the vehicle’s original wiring and mounting points.
