Description
Passenger Airbag Switch For Various Citroën And Peugeot Models
This passenger airbag switch is a direct-fit replacement used on a range of Citroën and Peugeot models. It allows manual deactivation of the front passenger airbag where required (for example when using a rear-facing child seat) and is commonly searched by OE numbers 96373645XT and 8216F2.
Application And Key Features
Designed for compatibility with selected Stellantis vehicles from the Citroën and Peugeot families, this switch performs the simple but safety-critical function of enabling or disabling the front passenger airbag. Features include a clearly marked on/off position, factory-style connector for plug-and-play fit (subject to vehicle wiring and configuration), and mounting compatible with original dashboard or glovebox apertures.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model(s): Citroën Berlingo; Citroën C5; Citroën Xsara Picasso; Peugeot Partner
- Product Codes: 96373645XT; 8216F2
- Other Numbers: 8216F2 | 96373645XT
Function
The switch provides a manual control to deactivate the passenger airbag circuit when carrying an occupant or child seat that requires airbag deactivation. In vehicles equipped with a passenger airbag status indicator, the switch position is communicated to the vehicle’s restraint system so that the passenger airbag is physically prevented from deploying when switched off.
Installation Recommendations
Follow these general steps and safety rules when replacing the switch. Always refer to the vehicle manufacturer’s repair procedure for model-specific details.
- Disconnect the negative battery terminal and wait at least 2–3 minutes to allow the airbag system capacitors to discharge.
- Remove the required trim or glovebox panels to access the switch location; keep fasteners and clips for reassembly.
- Unplug the electrical connector and release any retaining clips or screws holding the switch in place.
- Install the replacement switch, engage the connector, and reassemble trim. Ensure the switch is secure and correctly aligned.
- Reconnect the battery. Verify proper operation by confirming the passenger airbag status indicator and, if available, by reading the SRS system with a diagnostic tool to clear or confirm fault codes.
Safety Note: Always observe electrostatic discharge precautions and avoid shorting airbag system circuits. If in doubt, have the replacement performed by a qualified technician.
Why This Part Fails
Passenger airbag switches typically fail for mechanical or electrical reasons: wear of internal contacts from repeated use, corrosion or contamination in the connector, damage from moisture ingress, or physical damage after collisions or improper removal. Faulty switches may cause SRS warning lights, loss of ability to deactivate/activate the airbag, or intermittent behavior.
Additional Advice
There is no scheduled replacement interval for the passenger airbag switch; replace when faulty, damaged, or when required by safety equipment changes (child seats). Because the switch interacts directly with the vehicle restraint system, ensure correct installation and confirm the SRS system reports no active faults after fitting.
Search And Identification
This part is frequently searched by its OE numbers 96373645XT and 8216F2. Use these codes when checking fitment against vehicle parts lists or catalogues for the listed models.
