Description
Passenger airbag switch for CITROËN C1, C2, C3 including Pluriel and PEUGEOT 607
This passenger airbag switch is an OEM-style replacement designed for Stellantis vehicles and commonly referenced under part numbers 96373215ZL and 8216E6. Ideal for professional workshops and DIY mechanics, the switch allows controlled deactivation of the front passenger airbag where required (for example when using a rearward-facing child seat) and is frequently searched by its product codes. Durable in everyday use, the unit restores correct on/off indication and safe operation of the passenger airbag circuit when original controls become worn or inoperative.
Designed with fitment and safety in mind, this switch matches the factory interfaces and electrical connectors used on the listed Citroën and Peugeot models. Replacing a faulty switch returns full control and visual feedback of the airbag deactivation function, which is important for vehicle safety compliance and workshop diagnostics.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C1, Citroën C2, Citroën C3, Citroën C3 Pluriel, Peugeot 607
- Product Codes: 96373215ZL, 8216E6
- Additional Numbers: 8216000000
Function And Typical Use
The passenger airbag switch enables manual deactivation of the front passenger airbag. It is used when it is unsafe to have the airbag active, for instance when a rear-facing child seat is fitted in the front passenger position. The switch communicates with the airbag control unit and provides a visual indicator of the airbag status on the dashboard.
How To Replace
Replacement is straightforward for a trained technician or competent DIY mechanic familiar with SRS systems. General steps:
- Disconnect the negative battery terminal and wait the manufacturer-recommended time to allow SRS capacitors to discharge.
- Remove the relevant dashboard trim or glovebox panel to access the switch mounting point.
- Unplug the electrical connector and release any retaining clips, then remove the old switch.
- Fit the replacement switch, reconnect the connector and secure trims back in place.
- Reconnect the battery and check indicator illumination and system fault status with a diagnostic tool if available.
Installation Recommendations
- Follow vehicle manufacturer safety procedures for work on SRS circuits. Work only with the battery disconnected and after capacitors have discharged.
- Use the correct trim removal tools to avoid damaging panels and retainers.
- Verify connector seating and pin condition before reassembly; corrosion or bent pins can cause intermittent faults.
- After replacement, confirm airbag indicator behavior and scan for SRS fault codes; clearing or diagnosing codes may require a diagnostic tool.
Reason Why The Part Most Often Fails
Failure typically results from wear of the mechanical switch mechanism or contact degradation inside the switch caused by repeated use, contamination, or moisture ingress. Electrical connector corrosion or damage to wiring from panel removal can also produce loss of function. In some cases, dashboard impact or interior repairs that disturb the switch assembly result in a failed or intermittent contact.
This airbag switch is a low-cost serviceable item that restores proper control and indication of the passenger airbag circuit when replaced correctly. Always follow safety steps when working on systems related to occupant restraint.
