Description
Front wiper motor for Citroën C3 III and Peugeot 208 and 2008
Overview
This front wiper motor is designed for Citroën C3 III and Peugeot 208 / 2008 models and carries the common OEM references used when searching for direct-fit replacements. It drives the wiper linkage assembly, providing reliable wiping motion and the park function that returns the arms to rest position. The unit is suitable for professional workshops and competent DIY fitters who need a robust replacement part bearing the part numbers 9815497780 and 3397021910.
Why Choose This Wiper Motor
- Direct Fit For Citroën C3 III And Peugeot 208 / 2008: Matches OE mounting points and electrical connector layout for straightforward replacement.
- Search-Focused Part Numbers: Commonly looked up under 9815497780 and 3397021910—helps customers and mechanics find the correct unit quickly.
- Reliable Wiping And Park Operation: Designed to provide consistent torque for clearing the windshield and to park the wipers correctly at power-off.
Replacement And Installation
The replacement process is standard for front wiper motors. Typical steps are:
- Disconnect Battery: Always disconnect the negative terminal before starting to avoid short circuits and protect vehicle electronics.
- Remove Wiper Arms: Lift arms to service position and remove retaining nuts. Mark arm positions to preserve alignment.
- Remove Cowl/Trim: Remove the plastic cowl or grille to access the motor and linkage assembly.
- Disconnect Electrical Connector: Unclip the wiring harness from the motor socket.
- Unbolt Motor And Linkage: Remove mounting bolts and free the motor from the linkage (note orientation and park position).
- Install New Unit: Fit the new motor, secure mounting bolts to manufacturer torque, reconnect the electrical connector and reassemble the cowl.
- Align Wiper Arms And Test: Refit wiper arms to marked positions, tighten nuts, reconnect battery and test full sweep and park function. Adjust arm position if necessary.
How Often It Fails And Common Causes
Service life depends on use and environment. Typical reasons for failure include:
- Electrical Wear: Worn brushes or internal commutator wear can reduce motor performance over time.
- Water Ingress And Corrosion: Moisture entering the motor housing or connector area can lead to corrosion and electrical faults.
- Mechanical Seizure: Linkage joints may seize or accumulative play can overload the motor, causing premature failure.
- Overload From Frozen Wipers: Operating wipers on an iced windshield can overload and burn out the motor.
- Blown Fuses Or Relays: External electrical faults in the circuit or a faulty park switch can mimic motor failure.
With normal use and proper sealing, wiper motors often last many years; heavy use or harsh weather can shorten service life to a few years.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot Applications)
- Model: Citroën C3 III; Peugeot 208; Peugeot 2008
- Product Codes: 9815497780
- Other Numbers: 3397021910
Installation Recommendations
- Disconnect Battery Before Work: Prevents short circuits and protects vehicle electronics.
- Mark Wiper Arm Positions: Ensures correct alignment after reassembly and avoids motor overload.
- Inspect Linkage And Mounts: Replace seized or heavily worn linkage joints to prevent premature failure of the new motor.
- Protect Electrical Connections: Ensure connectors are dry and make good contact; use dielectric grease where appropriate to prevent corrosion.
- Test Full Cycle And Park Function: Verify correct park position and smooth sweep before finishing assembly.
Most Common Reason For Failure
The most frequent cause is water ingress and corrosion around the motor and connector area, often combined with wear of internal brushes. This leads to intermittent operation or complete stoppage. Mechanical overload from frozen or obstructed wipers is another common failure mode.
