Description
Electric window regulator mechanism for the right front window for Citroën C3 II (A51). Side – front passenger door. Includes electric motor. 6PIN connector.
This direct-fit electric window regulator with integrated motor is designed for the right front (passenger side) door of Citroën C3 II (A51). Supplied with the motor and 6-pin connector, the unit is commonly referenced under part numbers 9222FQ and 9802617380. Ideal for professional workshops and DIY enthusiasts, this replacement restores reliable window operation and reduces diagnostic and repair time compared with repairing worn cable paths or damaged guide clips.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C3 II (A51)
- Product Codes: 9222FQ, 9802617380
- Additional Numbers: 6PIN
Function And Application
The mechanism raises and lowers the front passenger window using an electric motor that drives the regulator assembly. It converts rotary motion into linear movement to move the glass along its guides. This assembly is intended as a direct replacement for the original equipment on Citroën C3 II (A51) passenger-side front doors and is suitable for technicians and experienced DIYers searching by OEM code.
How The Part Is Replaced
- Remove the interior door trim and any retained insulation or moisture barrier to access the regulator.
- Support the glass in its current position (tape or a support tool) and detach the glass from the regulator if required.
- Disconnect the electrical connector (6-pin) and remove the fasteners securing the regulator and motor.
- Withdraw the old regulator assembly and fit the replacement unit, aligning mounting points and glass seating.
- Reconnect the motor, test window operation before reassembling the door, adjust glass alignment if necessary, and re-fit the door trim.
Installation Recommendations
- Disconnect the negative battery terminal before beginning work to prevent short circuits and accidental operation.
- Support the window glass securely when removing the regulator to avoid breakage and misalignment.
- Inspect and clean the window channels and drain holes; lubricate guide rails with appropriate grease to reduce wear.
- Check and replace any damaged plastic clips or fasteners; use correct torque on mounting bolts to avoid deformation.
- Test full travel and sealing after installation to ensure quiet, smooth operation and correct alignment.
Why The Part Most Often Fails
- Motor Wear: Commutator and brush wear in the motor over time causes slow or intermittent operation.
- Cable Or Guide Wear: Fraying cables, stretched linkages or worn plastic guides lead to binding and excessive load on the motor.
- Plastic Clip Failure: Retaining clips and sliders are subject to fatigue and can break, causing the glass to detach from the regulator.
- Water Ingress And Corrosion: Moisture entering the door can corrode components and seize moving parts.
- Mechanical Shock Or Obstruction: Forcing the window when obstructed or impact damage can bend tracks and overload the regulator.
Searchable by OEM codes 9222FQ and 9802617380, this unit provides a practical solution to restore reliable window operation on Citroën C3 II (A51) passenger-side front doors. Suitable for professional fitment or competent DIY replacement when following recommended safety and installation steps.
