Description
Complete engine wiring harness for Citroën and Peugeot vehicles with 1.6 16V NFU engine. It is from a Citroën C4 2006.
This complete engine wiring harness is designed for vehicles equipped with the 1.6 16V NFU petrol engine and is ideal for professional workshops and DIY mechanics who need a reliable replacement harness. The harness carries all engine sensor and actuator signals, including ignition, injection, cam/crank sensors, throttle, and main engine grounds. Frequently searched under part numbers 9657134480 and 656940, this assembly helps restore electrical integrity after damage from mechanical wear, corrosion, or accidental tearing. Supplied as a full harness assembly, it reduces repair time compared with piecemeal wiring repairs and ensures correct connector types and lengths for straightforward refitment.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C4 (2006). Also Fitment: Peugeot 307 (vehicles equipped with 1.6 16V NFU engine)
- Product Codes: 9657134480, 656940, NFP
- Other Numbers: 656940
Recommended Installation
- Disconnect Battery: Always disconnect the negative battery terminal before starting any work on the electrical system.
- Preparation: Compare the replacement harness to the removed part, label connectors and routing points, and note clip and bracket locations.
- Routing And Securing: Route the harness following original clip points and protective conduits. Secure with OEM-style clips to prevent chafing and heat exposure.
- Connector Care: Inspect connectors for corrosion or damaged pins. Use contact cleaner and apply dielectric grease to prevent future corrosion where appropriate.
- Grounds And Shields: Ensure all ground straps are clean, tight, and free of paint or rust. Replace damaged shielding to prevent EMI issues.
- Final Checks: Reconnect the battery, clear any stored fault codes, and perform functional checks for sensors, ignition, and fuel injection circuits. Verify charging and starter circuits operate correctly.
Common Failure Causes
- Mechanical Damage: Abrasion against engine components, routing points missing clips, or accidental cuts during repairs.
- Thermal Degradation: High under-hood temperatures can harden insulation and expose conductors over time.
- Corrosion: Moisture ingress into connectors leads to poor contacts and intermittent faults.
- Oil And Chemical Exposure: Leaking engine oil or fuels can degrade insulation and connector seals.
- Rodent Damage: Chewing of wiring by rodents is a common source of localized failures.
- Connector Fatigue: Repeated disconnects or damaged retention tangs result in poor mating and electrical issues.
Why This Harness
Replacing a damaged engine wiring harness with a complete assembly restores factory routing, connector types, and signal integrity—reducing diagnostic time and preventing recurring faults. The harness listed under the common part numbers above is a practical choice for technicians repairing 1.6 16V NFU-powered Citroën and Peugeot cars. Always follow proper installation steps and inspect mating components (sensors, actuators, fuses, and relays) when performing the swap to ensure a lasting repair.
Service Life And Notes
Wiring harnesses can last the lifetime of the vehicle under normal conditions, but actual service life depends on environment and maintenance. Addressing leaks, securing routing points, and protecting against heat and rodents significantly extends service life. If intermittent electrical faults, blown fuses, or multiple sensor errors occur, inspect the harness routing and connectors as part of diagnostics.







