Description
Window switch for PEUGEOT 407 with mirror folding function. This is a used part.
Product Overview
This replacement window switch is designed for the Peugeot 407 and integrates the electric window controls with the mirror folding function. Built to the original OE form and fit, it is a practical spare for workshops and DIY mechanics who need a direct swap to restore reliable window and mirror operation. The unit arrives used and is suitable for vehicles where the original switch has failed, is intermittent, or the mirror fold feature no longer responds.
Key Benefits
- Direct Fit For Peugeot 407 — Quick Replacement To Restore Window And Mirror Folding Functions
- OE Form And Connector Compatibility — No Modifications Required In Most Cases
- Cost-Effective Solution For Workshops And Home Mechanics
How It Works
The module controls the up/down motion of the electric windows and sends the command to the mirror folding motors when the folding function is activated. Internally it uses mechanical switches and electrical contacts; the unit routes power and control signals between the door wiring harness and the window motors/mirror actuators.
How To Replace On The Vehicle
- Disconnect The Battery To Prevent Short Circuits And Unintended Operation.
- Remove The Door Trim Panel: Remove Screws And Carefully Release Clips Around The Door Card.
- Disconnect The Electrical Connector From The Old Switch And Release Any Retaining Clips.
- Remove The Old Switch, Fit The Replacement, Reconnect The Connector And Test Window And Mirror Functions Before Reassembling The Door Trim.
- Reassemble The Door Trim, Ensure All Clips And Screws Are Secured, And Perform Final Function Check.
Installation Recommendations
- Disconnect The Battery Before Starting Work To Avoid Short Circuits And To Protect Vehicle Electronics.
- Inspect The Door Wiring Harness For Corrosion Or Pin Damage; Clean Connectors If Needed.
- Test The Replacement Switch Before Final Reassembly To Confirm Windows And Mirror Folding Work Correctly.
- Use Plastic Trim Tools To Avoid Damaging Trim Clips And Door Panels.
- If Electrical Faults Persist After Replacement, Check Window Motors, Relays, And Fuses In The Circuit.
Most Common Failure Reasons
- Wear Of Internal Contacts Due To High Cycle Use — Leads To Intermittent Or No Operation.
- Moisture Ingress And Corrosion — Especially On Older Vehicles Or If Door Seals Are Compromised.
- Mechanical Damage To The Switch Rocker Or Housing — Caused By Forceful Operation Or Impact.
- Damaged Connector Pins Or Wiring — Resulting In Loss Of Power Or Intermittent Signals.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 407
- Product Codes: 96468704XT, 6554ER
- Other Numbers: NFP
- Condition: Used
Fitment Notes
Common Fitment: Peugeot 407 (Saloon, SW, Coupé) — Typical Model Years 2004–2011. Verify That The Connector Shape And Mounting Points Match Your Door Trim Before Installation.
Final Tips For Mechanics And DIYers
When replacing the switch in a workshop environment, keep a record of the vehicle configuration and test all door switches after installation. For intermittent faults, inspect the wiring loom and window regulators as the root cause may be elsewhere in the circuit. This used switch provides an effective repair option when the original control has failed due to wear or moisture.
