Description
Window switch for Peugeot 407. With mirror folding function. This is a used part.
This power window and mirror folding switch is a direct-fit replacement for Peugeot 407 drivers looking for a reliable control module. Designed to operate window motors and the mirror folding function from the door panel, the switch is a common replacement part for workshop and DIY repairs. Listing the OEM reference numbers in the product title and description increases findability in searches—enter the part numbers 96468704XT or 6554ER when searching for compatibility.
Function And Fitment
The unit controls front and/or rear electric windows depending on vehicle wiring and also integrates the mirror folding command. It is compatible with Peugeot 407 models equipped with electric windows and folding mirrors. The module fits into the door trim panel on the driver’s side and connects to the vehicle wiring harness via a multi-pin connector.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Peugeot 407
- Product Codes: 96468704XT
- Additional Numbers: 6554ER, NFP
Installation Recommendations
Before starting, disconnect the negative battery terminal to avoid short circuits and accidental motor operation. Typical replacement steps:
- Remove the door trim screws and use a plastic trim tool to unclip the panel carefully to avoid breaking retaining clips.
- Peel back the door card enough to access the switch assembly and wiring connector.
- Release the electrical connector and unfasten any screws or clips holding the switch module in place.
- Swap the used switch with the replacement, reconnect the wiring and test all window and mirror-folding functions while the door trim is still loose.
- Reassemble the door card and tighten all fasteners, then reconnect the battery and perform a final function check.
Recommended tools: flat and Phillips screwdrivers, Torx set (if applicable), socket set, plastic trim tools, and a multimeter for verifying power and ground if troubleshooting is required.
Most Common Failure Reasons
- Wear of internal contacts and microswitches from frequent use, causing intermittent or complete loss of function.
- Corrosion or dirt ingress into the connector or switch housing, often due to moisture entering the door cavity.
- Mechanical damage to the switch housing or mounting clips from forceful operation or improper removal.
- Faulty wiring or poor connector contact resulting in intermittent operation; sometimes traced to broken strands in the door flex region.
Practical Tips
Because this is a used part, inspect the plastic housing, mounting tabs and electrical connector for damage before installation. Test every window position and the mirror folding function immediately after connection and before final reassembly. If symptoms persist after swapping the switch, check fuses, grounding points and window motor condition to isolate the fault.
Suitable For Mechanics And DIYers: The unit is straightforward to replace with basic workshop tools, but care during door trim removal and connector handling will prevent additional repairs. Keeping the original part numbers handy (96468704XT, 6554ER) helps ensure you find matching replacements or cross-references quickly.
