Description
Kinetic ESP Sensor BOSCH For Citroën C4, C8 And Peugeot 307, 807
This Bosch ESP (Electronic Stability Program) sensor is a direct-fit replacement designed for Citroën and Peugeot models. It supplies the ESC/ABS control unit with critical motion data to detect yaw and help maintain vehicle stability during cornering and emergency maneuvers. Ideal for fleet workshops, independent garages and competent DIYers who search by product number, this unit restores correct stability control feedback and clears related fault codes when fitted and calibrated correctly.
Technical Information
- Manufacturer: Bosch
- Model: Citroën C4, Citroën C8, Peugeot 307, Peugeot 807
- Product Codes: 0265005606, 265005606
- Additional Numbers: 454917, 9649776180, 454917 NFP
Function And Typical Symptoms
The sensor measures vehicle yaw/rotation (motion around the vertical axis) and relays that information to the ESP/ABS control module. When the sensor works correctly, the stability control system can intervene to correct oversteer or understeer situations. Common symptoms of a faulty sensor include:
- ESP/ABS warning light illuminated on the dashboard
- Intermittent or permanent loss of traction control intervention
- Unusual or delayed stability control reaction during cornering
- Stored fault codes related to yaw rate or lateral acceleration sensors
Replacement And Installation Recommendations
For a safe and reliable replacement, follow these general steps and best practices:
- Disconnect The Battery: Always isolate the negative battery terminal before starting to avoid electrical shorts.
- Access The Sensor: Depending on the model, the sensor is usually located on the body centerline under the dash, on the transmission tunnel, or near the steering column—remove trim panels as required.
- Unplug And Remove: Disconnect the electrical connector, unbolt the sensor and carefully remove it. Note Orientation—many sensors must be installed in a defined position.
- Fit New Unit: Install the replacement sensor in the same orientation, secure mounting bolts and reconnect the electrical plug. Tighten fasteners to the manufacturer’s specified torque.
- Calibration: After installation, perform a zero-point calibration / adaptation with a diagnostic tool or scan tool that supports ABS/ESP functions. Clearing fault codes and a short road test are recommended to confirm correct operation.
Tools Needed: Basic hand tools, trim tools and a diagnostic scanner capable of ESP/ABS sensor adaptation. If you are not equipped with a suitable diagnostic tool, a professional workshop can perform the calibration.
Why This Part Typically Fails
- Water Ingress Or Corrosion: Moisture penetration or corroded connectors can damage sensor electronics.
- Physical Impact Or Accident Damage: Sensors mounted near the vehicle centerline can be affected by collisions or heavy impacts.
- Electrical Faults: Wiring harness damage, short circuits or poor grounding will cause intermittent or permanent failure.
- Aging Electronics: Over time, internal components can degrade, causing incorrect signals or total failure.
Buy With Confidence: This Bosch sensor is commonly searched by its part numbers (e.g., 0265005606, 9649776180) and is intended as a direct replacement for the listed Citroën and Peugeot models. Proper installation and calibration restore full ESP functionality and remove related dashboard warnings, ensuring safe vehicle handling.
