Description
HELLA Throttle Pedal For CITROEN And PEUGEOT Vehicles. Accelerator Pedal.
The HELLA throttle (accelerator) pedal is a direct-fit electronic pedal unit designed for a range of Citroën and Peugeot models. Built as an electronic potentiometer/drive-by-wire input, this pedal converts driver input into an accurate electrical signal for the engine management system, delivering smooth throttle response and reliable control. Supplied with OEM-style connectors and mounting points, it is commonly referenced by part numbers such as 9680756880 and 1601T5.
Features And Benefits
– Precise position sensing for consistent throttle control and improved drivability.
– Direct replacement for original equipment on compatible Citroën and Peugeot models.
– Helps resolve engine management fault codes related to pedal position sensors and drive-by-wire systems.
– Robust plastic and electronic construction designed for long service life under normal operating conditions.
Technical Information
- Manufacturer: HELLA
- Model(s): Citroën C2, Citroën C3, Citroën C3 Pluriel, Peugeot 1007, Peugeot 207, Peugeot 307
- Product Codes: 9680756880, 1601T5, 1601.AW, 1601.T5, 1601AW
- Additional Numbers: Diagnostic codes commonly associated: P0120–P0123, P0220–P0223
Function
The throttle pedal assembly contains position sensors that measure pedal travel and send a proportional electrical signal to the engine control unit. In modern drive-by-wire systems there is no mechanical cable to the throttle body—control is entirely electronic—so pedal sensor accuracy and connector reliability are critical for safe engine operation and predictable throttle response.
Installation Recommendations
– Always Disconnect The Battery Before Work To Prevent Short Circuits And Avoid Fault Codes.
– Remove Lower Dash Trim To Access The Pedal Assembly, Unplug The Electrical Connector, And Remove Retaining Bolts Or Screws.
– Install The Replacement Pedal Ensuring Correct Orientation, Secure Mounting, And That Wiring Harnesses Are Routed Without Tension.
– After Fitting, Reconnect Battery, Check For Smooth Pedal Travel And Proper Return, Clear Any Stored Fault Codes, And Perform Throttle Relearn/Adaptation If Required By The Vehicle (Using A Manufacturer-Compatible Diagnostic Tool Where Necessary).
– Tighten Fasteners To Manufacturer Specified Torque Values—If Unknown, Consult Service Manual Or Professional Technician.
Most Common Failure Reasons
– Sensor Drift Or Internal Potentiometer Wear Leading To Erratic Signals.
– Electrical Connector Corrosion Or Damaged Wiring Causing Intermittent Faults.
– Contamination From Moisture Or Debris Causing Sticking Or Loss Of Signal Integrity.
– Mechanical Damage To The Pedal Body Or Return Mechanism From Impact Or Excessive Force.
– Symptoms Often Include Check Engine Light, Reduced Engine Power (Limp Mode), Hesitation, Jerky Acceleration, Or Specific Fault Codes P0120–P0123 / P0220–P0223.
Why Replace
Faulty pedal position sensors directly affect vehicle drivability and safety. Replacing a worn or damaged pedal restores reliable throttle response, removes intermittent faults, and prevents prolonged engine management issues. For workshop professionals and experienced DIYers, this unit is a cost-effective repair when symptoms point to the pedal or its wiring.
Notes For Professionals
This pedal is intended as a direct replacement part for the listed models and part numbers. Ensure diagnostic verification after installation and perform any required calibration or adaptation procedures. If vehicle reports persistent faults after replacement, inspect wiring, grounds, and the throttle body actuator for related issues.
