Description
Window regulator mechanism for the right front window for Peugeot 308 First Series. Motor can be purchased separately.
The right front window regulator for Peugeot 308 is a direct-fit replacement part designed for mechanics and DIY enthusiasts who demand reliability and correct fitment. This mechanism controls smooth raising and lowering of the passenger-side front window and is often searched by part numbers 9658926980, 9675466080 and 9222CV. Built to interface with the factory door hardware, it restores proper window movement, reduces wind noise and prevents glass misalignment.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 308 First Series (Right Front)
- Product Codes: 9658926980, 9675466080, 9222CV
- Additional Numbers: 9222.CV, 9222CV/9222.CV, 9658926980
Function And Typical Symptoms
The regulator assembly guides and supports the door glass and transmits motion from the electric motor (if fitted) to lift or lower the window. Typical failure symptoms include slow or jerky window travel, window dropping down inside the door, unusual noises (grinding or clicking), or complete lack of movement if the motor is defective. In many cases the mechanical regulator fails before the motor, but both items should be checked when diagnosing the fault.
Why This Part Fails
- Wear Of Plastic Components Or Guides: Repeated use causes plastic sliders and guides to wear or fracture, leading to misalignment.
- Cable Fraying Or Detachment: Cable-driven regulators can suffer from cable stretch or breakage, causing loss of control.
- Corrosion And Water Ingress: Moisture inside the door accelerates corrosion on metal parts and can jam moving elements.
- Motor Wear (If Fitted): Electric motors may lose torque over time or seize, especially if bearings degrade.
- Impact Or Door Damage: Door impacts can deform mounting points or bend tracks, compromising regulator operation.
Replacement Procedure (Overview)
Useful For: Experienced DIYers And Professional Technicians. Typical tools required include a trim removal tool, Torx and Philips screwdrivers, socket set, pliers and a small pry tool.
- Prepare The Vehicle: Park on a level surface and isolate the electrical system by disconnecting the battery to avoid short circuits while working on the door electrics.
- Remove Door Trim: Carefully remove door card clips and fasteners to access the inner door panel. Keep all fasteners organized.
- Detach Electrical Connectors: Disconnect the window switch, speaker and any door harness connectors to free the trim panel.
- Support The Glass: Before removing the regulator, support the glass (tape or a wedge) to prevent it from falling when the regulator is detached.
- Remove Motor (If Fitted) And Bolts: Unbolt the motor and regulator assembly from the door inner panel. If motor is being reused, note gear alignment.
- Install New Regulator: Position the new regulator, loosely fit bolts, then align the glass and tighten fasteners to specification.
- Reconnect And Test: Reconnect motor and switches, briefly reconnect the battery and test window travel through full stroke to confirm smooth operation before final reassembly.
- Reassemble Door Trim: Once operation is confirmed, re-fit the door card, connectors and all trim pieces.
Note: The Motor Can Be Purchased Separately If Only The Motor Is Faulty.
Installation Recommendations
- Check All Mounting Points And Clips: Replace any damaged clips or fasteners to ensure a firm fit and prevent rattle.
- Lubricate Moving Parts: Use suitable door-track grease on guides and sliders to prolong service life and reduce noise.
- Align Glass Carefully: Improper alignment can cause binding and premature wear. Adjust until the window runs freely without rubbing the seals.
- Test Before Full Reassembly: Verify smooth operation and correct travel limits before fitting the door card to avoid repeating the job.
- Consider Replacing Worn Related Parts: If the motor shows signs of wear, replace it at the same time to avoid future removal of the new regulator.
Who Should Fit This Part
This window regulator is suitable for skilled DIYers who are familiar with door trim removal and electrical connectors, as well as professional auto technicians. If you are unsure about tools or procedures, have the replacement carried out by a garage to ensure correct alignment and safe reassembly.
Common Search Terms: Peugeot 308 window regulator, right front window regulator Peugeot 308, 9658926980, 9675466080, 9222CV.
