Description
Speaker for Citroën and Peugeot vehicles. Diameter 165 mm.
High-quality 165 mm replacement speaker designed for a wide range of Citroën and Peugeot models. This unit is a direct-fit audio component commonly sought under original part numbers and aftermarket references (see Technical Information below). Ideal for professional workshops and experienced DIY enthusiasts who need a reliable, easy-to-install speaker to restore factory sound or upgrade a worn original. The compact 165 mm size delivers clear midrange reproduction and integrates seamlessly with the vehicle’s original mounting points and wiring harness.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën C2; Citroën C3; Citroën C3 Picasso; Citroën C3 Pluriel; Citroën C4 Picasso; Citroën C5; Citroën C5 X7; Citroën C8; Citroën Xsara Picasso; Peugeot 207; Peugeot 3008 I; Peugeot 308; Peugeot 407; Peugeot 5008 I; Peugeot 807
- Product Codes: 9664955880, 6562X2, 6562C5
- Other Numbers: 6562.C5, 6562.X2, 6562C5, 6562X2, 9664955880
- Size: 165 mm (6.5″) Diameter
Installation Recommendations
- Prepare Tools: Panel removal tools, Phillips/torx screwdriver set, socket set, and a multimeter for polarity check.
- Safety First: Disconnect the negative battery terminal before starting work to avoid short circuits and accidental airbag deployment when removing trim near A‑pillars.
- Remove Trim: Carefully remove the door card or trim panel following the vehicle manufacturer’s procedure to avoid breaking clips.
- Disconnect Old Speaker: Unscrew the original speaker, unplug the wiring harness, and note the polarity of the connectors or mark the positive lead.
- Fit New Speaker: Mount the replacement speaker into the original speaker aperture using the factory mounting points. Ensure the speaker sits flush and is secured without over‑tightening screws.
- Reconnect And Test: Reconnect the wiring (observe polarity), temporarily reconnect the battery, and test the speaker at low volume to confirm correct operation before reassembling the trim.
- Sealing And Vibration: Use a foam gasket or anti‑vibration pad if available to reduce rattles and improve acoustic sealing.
Why The Part Fails Most Often
- Age And Wear: Foam surrounds and suspension materials deteriorate over time, leading to distortion or rattling.
- Water Ingress: Moisture from door leaks or condensation can damage the cone, voice coil, or cause corrosion of terminals.
- Overdrive/Amplifier Faults: Excessive power or amplifier clipping can burn the voice coil, producing a blown speaker.
- Mechanical Damage: Physical impact during door repairs or improper installation can deform the cone or magnet assembly.
- Connector Corrosion Or Loose Contacts: Poor electrical connection causes intermittent sound or complete failure.
Search Tip: Many customers search by part numbers such as 9664955880, 6562X2 or 6562C5 — including these codes in your search will help you find the correct replacement quickly.
