Description
ESP And Parking Assist Switch For Peugeot 3008 And 5008 First Generation
This switch block operates the Electronic Stability Program (ESP) and Parking Assist functions on first‑generation Peugeot 3008 and 5008 models. It is a direct replacement part commonly searched by product codes 96656490XT, 96656490ZD and 6490V7. The unit allows drivers or technicians to enable/disable parking sensors and to interact with ESP system settings via the dashboard control, restoring full functionality when the original switch is worn or damaged.
Fitment And Application
Designed For: Peugeot 3008 I (First Generation) and Peugeot 5008 I (First Generation). Fits typical Stellantis/Citroën/Peugeot interior switch housings used on these models. Commonly referenced by the following product codes and tags, which helps mechanics and DIYers find the exact replacement.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 3008 I, Peugeot 5008 I (First Generation)
- Product Codes: 96656490XT, 96656490ZD, 6490V7
- Other Numbers: 6490.V7, 6490V7
Function And Symptoms
The switch sends user commands to the vehicle’s control logic to mute or enable parking sensors and to perform ESP-related driver interactions. Faulty units typically manifest as non‑responsive parking assist buttons, permanent parking sensor warning lights, ESP warning lamps, or intermittent operation of the related systems. Replacing the switch often restores normal control of these functions.
Replacement Procedure (Overview)
- Disconnect Battery: Always disconnect the negative battery terminal before starting to avoid short circuits and to protect vehicle electronics.
- Remove Trim: Use plastic trim tools to carefully remove the center console or lower fascia trim around the switch to avoid damaging clips.
- Unscrew / Unclip Switch Module: Locate and release the retaining screws or clips holding the switch block.
- Disconnect Electrical Connector: Unplug the multi‑pin connector; inspect pins for corrosion or bent contacts.
- Install New Switch: Plug in the replacement, secure the module and reassemble trim in reverse order.
- Test Before Final Assembly: Reconnect the battery and verify parking assist and ESP switch functions before fully refitting trims.
Mounting Recommendations
Always follow manufacturer safety procedures. Use non‑marring plastic trim tools to prevent damage to interior panels. Check connector contacts and wiring harness for signs of corrosion or damage while the switch is removed. After installation, confirm functionality with the ignition on and perform a short road test to ensure ESP and parking assist respond correctly. If the switch does not restore functionality, verify fuses and wiring integrity, or diagnose with a suitable diagnostic tool.
Why This Part Commonly Fails
- Mechanical Wear: Frequent use causes buttons and plastic actuators to wear or crack over time.
- Moisture Ingress: Spills or high humidity can corrode internal contacts and cause intermittent or permanent failure.
- Connector Corrosion or Damage: Faulty or loose wiring/connectors lead to loss of signal between the switch and vehicle modules.
- Impact Or Interior Damage: Accidental knocks or improper trim removal can break retaining clips or the switch housing.
Notes For Mechanics And DIYers
This is a commonly replaced interior electrical switch for Peugeot 3008 and 5008 first generation vehicles. Having the correct product code (96656490XT / 96656490ZD / 6490V7) helps ensure fitment. Basic installation is straightforward for experienced technicians; inspect surrounding wiring and fuses if issues persist after replacement.
