Description
Control Unit For Parking Assistant For Peugeot 308 T9. Front And Rear Sensors.
Product Summary
Bosch PDC (Park Distance Control) ECU for Peugeot 308 T9. This parking assist control unit processes signals from both front and rear ultrasonic sensors, manages audible and visual alerts and communicates with the vehicle CAN network. Ideal for professional workshops and experienced DIY mechanics looking for a direct replacement using OE part references.
Key Benefits
- Direct fit for compatible Peugeot 308 T9 vehicles using the listed part numbers.
- Supports both front and rear parking sensors for complete coverage.
- Helps restore reliable parking assistance and sensor diagnostics when replacing a faulty unit.
How It Works
The unit collects distance data from ultrasonic sensors, evaluates obstacle proximity and generates warnings via the vehicle buzzer and display systems. It also exchanges status and error codes over the CAN bus, enabling diagnosis through standard PSA diagnostic tools.
How To Replace
Replacement should be carried out by a trained technician or a competent DIYer with basic automotive electrical skills. Typical replacement steps:
- Disconnect The Battery Before Work To Avoid Short Circuits And Protect Vehicle Electronics.
- Access The Unit Through The Trunk Or Rear Interior Trim (Location May Vary By Model Year; Consult Repair Manual).
- Carefully Unplug Electrical Connectors And Release Mounting Fasteners.
- Install The Replacement Unit, Secure Fasteners And Reconnect Connectors Ensuring Proper Seal Against Moisture.
- Reconnect The Battery, Perform A System Check And Run A Diagnostic Scan To Clear Fault Codes And Verify Sensor Operation.
Technical Information
- Manufacturer: Bosch
- Model: Peugeot 308 T9
- Product Codes: 0263004802
- Other Numbers: 9811742080, 9813711480, 1613711480, 263004802
Installation Recommendations
- Always Disconnect The Battery Before Removal And Installation.
- Protect The Unit From Moisture And Contamination During Installation; Replace Damaged Seals.
- Inspect Wiring Harness And Sensor Connectors For Corrosion Or Damage; Clean Or Repair As Needed.
- After Mounting, Perform A Full Diagnostic Check And Sensor Self-Test Using A Compatible Diagnostic Tool.
- If You Are Unsure About Adaptation Or Fault Clearing, Use Professional Workshop Equipment For Calibration.
Why It Most Often Fails
Common causes of failure include moisture Ingress And Corrosion Of Connectors, Physical Damage From Low-Speed Impacts Near The Bumpers, Faulty Sensor Wiring Or Short Circuits From Water-Damaged Harnesses. Electrical Surges And Long-Term Exposure To Road Debris Or Salt Can Also Degrade Internal Components Over Time.
Who Should Buy
Recommended For Professional Auto Technicians And Experienced DIYers Repairing Peugeot 308 T9 Parking Systems. Useful When Replacing A Faulty PDC ECU Or Restoring Full Front/Rear Sensor Functionality. Searchable By The Listed Part Numbers For Faster Identification.







