Description
Bulb socket for the left rear lamp for PEUGEOT 3008 T84. Supplied with a short piece of wiring.
Product Description
This Used Bulb Socket Is Intended For The Left Rear Tail Lamp Of The PEUGEOT 3008 T84 (3008 I). It Replaces Worn Or Damaged Bulb Holders And Includes A Short Length Of Wiring For A Faster, Safer Swap. The Part Is Often Searched By Its Reference Numbers, So Listing The OEM Codes Below Helps You Find An Exact Fit Quickly.
Key Benefits
- Direct Fit For Left Rear Lamp Assemblies On PEUGEOT 3008 T84.
- Includes Wiring Pigtail To Avoid Cutting Factory Harness—Speeds Up Repair.
- Cost-Effective Replacement For Faulty Or Corroded Sockets.
- Commonly Searched By Product Codes (Use These In Parts Lookups Or Catalogs).
- Suitable For Professional Workshops And DIY Mechanics Who Perform Tail Light Repairs.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: PEUGEOT 3008 T84 (3008 I)
- Product Codes: 9683460880, 6350HC
- Other Numbers: 6350.HC, 6350HC, 9683460880
Installation Guidance
Designed For Mechanics And Competent DIYers. Typical Replacement Steps:
- Switch Off Ignition And, For Extra Safety When Working With Wiring, Disconnect The Negative Battery Terminal.
- Access The Left Rear Tail Light Assembly From The Boot/Trunk: Remove Trim Fasteners And Unscrew The Lamp Unit.
- Disconnect The Old Bulb Socket From The Housing And Unplug The Connector From The Vehicle Harness.
- Compare The New Socket And Wiring To The Old One (Pin Layout And Bulb Type). Fit The New Socket Into The Lamp Housing And Secure The Connector.
- If Required, Use Proper Crimps Or Soldering For Any Wire Joins, Protect Joints With Heat-Shrink Tubing, And Ensure A Secure Mechanical Fix To Avoid Strain.
- Test All Light Functions (Brake, Tail, Indicator, Reverse As Applicable) Before Reassembling The Lamp Unit.
- Reinstall The Lamp Assembly And Trim Panels, Then Reconnect The Battery.
Why This Part Fails Most Often
- Corrosion Of Contacts Due To Moisture Ingress Or Damaged Seals.
- Plastic Deformation Or Melting From Overheating (Incorrect Bulb Wattage Or Poor Contact).
- Broken Pins Or Cracked Housing From Vibration, Impact, Or Repeated Bulb Changes.
- Wiring Fatigue Where The Pigtail Meets The Harness—Especially On Older Vehicles.
Practical Tips
- Replace The Socket When You Replace A Bulb If Contacts Look Corroded Or Loose.
- Use Dielectric Grease On Contacts To Reduce Corrosion And Improve Electrical Contact.
- Verify Bulb Type And Wattage Against Manufacturer Specification To Avoid Overheating.
- Secure Wiring To Prevent Rubbing Against Sharp Edges; Use Cable Ties Or Protective Looms.
Compatibility Notes
Fits PEUGEOT 3008 T84 (First Generation) Rear Left Lamp Applications. Buyers Often Search Using The Product Codes 9683460880 Or 6350HC—Include These In Your Parts Search To Confirm Match With Your Lamp Unit.
