Description
Left rear lamp for Peugeot 3008 first generation. Without bulb sockets – these can be purchased separately. Driver side.
Direct-fit Left Rear Tail Light for Peugeot 3008 I, identified by part numbers 9683460880 and 6350HC. Designed for professional workshops and DIY mechanics who need a reliable replacement for a broken or worn rear lamp housing. This unit restores rear lighting functionality and vehicle appearance while matching OE mounting points for straightforward installation.
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 3008 I (First Generation)
- Product Codes: 9683460880, 6350HC
- Other Numbers: 6350.HC
- Side: Driver Side (Left)
- Notes: Supplied without bulb sockets; bulb holders and bulbs sold separately.
Fitment
Compatible with Peugeot 3008 First Generation models (3008 I). Verify model year and body style against listed part numbers 9683460880 / 6350HC when selecting the part.
Installation Recommendations
Basic replacement steps for a mechanic or competent DIYer:
1. Open the tailgate and remove the interior trim panel to access the lamp fasteners.
2. Unscrew the mounting bolts (usually 2–3) and carefully unclip any plastic retainers.
3. Disconnect the electrical connector from the lamp assembly.
4. Remove the old lamp, transfer any reusable seals or gaskets, and fit the new lamp into position.
5. Reconnect the wiring harness, secure the lamp with the original fasteners, and refit the trim panel.
6. Install bulb holders and bulbs if required, then test all functions (brake, tail, turn signal, reverse if applicable).
Safety tip: Before handling electrical connectors, isolate the vehicle electrical system or disconnect the negative battery terminal to reduce the risk of short circuits. Use dielectric grease on connectors and check seals to prevent moisture ingress.
Why The Part Commonly Fails
- Water Ingress: Damaged seals or cracked lenses allow moisture to enter, causing corrosion and electrical faults.
- Impact Damage: Bump or collision at the rear often cracks the housing or breaks mounting tabs.
- Plastic Fatigue: Mounting clips and tabs can become brittle over time and snap during removal or from vibration.
- Connector Corrosion: Oxidation on terminals or damaged wiring leads to intermittent or permanent failure of light functions.
- Bulb Holder Wear: Although this unit is supplied without bulb sockets, worn or corroded bulb holders in the vehicle can give the appearance of lamp failure.
Additional Tips
When replacing the rear lamp, inspect the surrounding seals and wiring harness for damage. Replace any brittle clips or degraded gaskets to maintain a watertight fit. Keep the part numbers 9683460880 and 6350HC handy when ordering bulbs, sockets, or future replacements to ensure correct compatibility.
Keywords: Left Rear Tail Light, Peugeot 3008 Tail Lamp, 9683460880, 6350HC, Rear Lamp Replacement, Driver Side Taillight.
