Description
Right rear lamp for PEUGEOT 3008 first generation. Without bulb sockets – these can be purchased separately. Passenger side.
This used right rear tail lamp is a direct-fit replacement for Peugeot 3008 first‑generation models and is ideal for professional mechanics and DIY enthusiasts looking for a reliable bodywork part. Supplied without bulb holders, it allows quick restoration of rear lighting after minor collisions, moisture damage or wear. The unit carries original manufacturer codes for straightforward identification (9683460780 / 6351HC) and fits the passenger side (right) of the vehicle.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 3008 I (First Generation)
- Product Codes: 9683460780, 6351HC
- Other Numbers: 6351.HC, (T84)
- Side: Right / Passenger Side
- Condition: Used body replacement part
- Notes: Supplied without bulb sockets—purchase and install correct bulb holders and bulbs separately.
Installation Recommendations
- Access the tail lamp from inside the luggage compartment: remove the trim panel to reach the lamp retaining screws or clips.
- Unscrew or unclip the fasteners, carefully pull the lamp assembly away from the body, and disconnect the wiring harness plug(s).
- Fit the new lamp into the body aperture, ensuring the sealing gasket seats correctly to prevent water ingress. Reconnect the wiring and secure the lamp with the original fasteners at correct torque.
- Replace bulb holders if not supplied and test all light functions (tail, stop, indicator, reverse if applicable) before reassembling interior trim.
- Always disconnect the negative battery terminal before working on vehicle electrics to avoid short circuits or damage to on‑board electronics.
Why The Part Fails Most Often
- Water Ingress And Condensation: Failed seals or cracks allow moisture to enter, causing corrosion, short circuits or fogging that reduces light output.
- Impact Damage: Rear collisions or minor bumps commonly crack the lens or break mounting points, making replacement necessary.
- Connector And Wiring Corrosion: Long‑term exposure to road salts and moisture can corrode pins and sockets, leading to intermittent or failed contacts.
- Bulb Holder Wear: Bulb sockets and clips degrade over time from heat cycles; if holders are missing or damaged, the lamp will not function until replaced.
Replacing the lamp restores both safety and appearance. For an efficient repair, use original or OEM‑equivalent bulb holders and ensure seals are intact to prevent repeat failures. This part is often searched by part number (9683460780 / 6351HC), so matching codes will speed up identification and ordering.
