Description
Engine Wiring Harness Citroën Peugeot 2.0 16V 130KW RFK From 2004 Peugeot 307 CC !!!! Missing one two-wire connector — see second photo !!!!
This used engine wiring harness is designed for PSA 2.0 16V RFK applications and carries the main power and signal circuits between the engine management, sensors, actuators and body harness. It routes injector and ignition coil feeds, sensor signals (crankshaft/camshaft position, coolant temperature, throttle, airflow/Lambda where applicable), alternator and starter connections, grounds and immobiliser/ECU connectors. Supplied with product codes commonly searched by mechanics and DIY enthusiasts, this harness is a practical replacement for vehicles matching the listed references.
Key Benefits
– Direct fit for compatible PSA 2.0 16V RFK installations when matching part numbers are used.
– Saves time by matching original routing, clips and connector types where present.
– Ideal for professional workshops and experienced DIYers who repair Peugeot/Citroën engines.
Compatibility & Notes
Fits selected Citroën and Peugeot petrol 2.0 16V RFK models. Common applications include Peugeot 307 CC (2004) and other 307/206 and Citroën C4 variants using the 2.0 16V RFK engine wiring layout. Always verify fitment by matching the product codes listed below before installation. This specific item is missing one two-wire connector as shown in the second photo — factor this into fitment and electrical function.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Peugeot 307 CC (2004), Peugeot 307, Peugeot 206, Citroën C4 (2.0 16V RFK Applications)
- Product Codes: 9651728880, 9659205180, 6558WG
- Other Numbers: RFK, 130 kW, NFP
Installation Recommendations
- Preparation: Work in a well-lit area with the engine cold. Have basic hand tools, connector release tools and cable ties ready.
- Safety: Always disconnect the negative battery terminal before starting to avoid short circuits and ECU damage.
- Removal: Label all connectors and their positions before unplugging. Remove obstructing components (intake ducting, engine covers) to gain access to harness routes and fastenings.
- Installation: Route the harness following original clips and protective looms. Ensure all earths are clean and tight. Replace any damaged clips or retainers to prevent chafing.
- Final Checks: Reconnect the battery, visually inspect for pin damage or loose connections, and clear any diagnostic trouble codes if present after installation.
Most Common Failure Reasons
- Mechanical Wear: Vibration, heat cycles and engine movement can chafe insulation or break wires at clip points and harness bends.
- Corrosion: Water ingress at connector seals or damaged insulation leads to poor contacts and intermittent faults.
- Accident Damage or Repairs: Previous repairs or collision damage can leave stretched or incorrectly routed wiring that later fails.
- Thermal Degradation: Prolonged exposure to high underbonnet temperatures can harden and crack insulation, causing short circuits.
Practical Tips
– When replacing the harness, compare pinouts and connector shapes one-by-one with the original to avoid miswiring.
– Replace damaged grommets and use dielectric grease in exposed connectors to reduce corrosion risk.
– Secure loose sections away from hot components like exhaust manifolds and turbochargers to extend service life.
Search Keywords: Engine Wiring Harness, Citroën, Peugeot, 2.0 16V, RFK, 130 kW, 9651728880, 9659205180, 6558WG — often used by mechanics and DIY installers when locating the correct part.







