Description
Electric window regulator motor for Peugeot 3008 and 5008 first generation. Rear left (driver-side rear).
Product Overview
This electric window regulator motor is designed for the rear left door of first-generation Peugeot 3008 and 5008 models. It replaces the internal drive unit that moves the window glass up and down and is frequently searched by its product codes 9682808780, 1607675380 and 9223F2. Suitable for professional workshops and experienced DIY mechanics who perform door repairs and part replacements.
Key Benefits
- Direct fit for Peugeot 3008 I and 5008 I — ensures correct alignment and operation when installed properly.
- Improves window operation: restores smooth, reliable up/down movement and reduces noise or stuttering caused by worn components.
- Includes common OEM reference numbers in the description to aid quick searches and part identification.
Function And Typical Faults
The unit houses the electric motor and gearbox that drive the regulator mechanism. Its function is to convert electrical input from the window switch into mechanical movement that raises and lowers the glass. Failures typically occur due to worn gears, degraded brushes in the motor, corrosion from moisture ingress, damaged cable guides or seized sliders. Symptoms before total failure include slow or noisy movement, intermittent operation, or the glass getting stuck.
Replacement Guidance
Replacing the rear left window motor is a moderate workshop task. Recommended for professional mechanics or competent DIYers with basic door trim experience. Typical replacement steps:
- Disconnect the vehicle battery before starting to avoid electrical short or accidental window movement.
- Remove interior door trim panel and any plastic vapour barrier carefully to access the regulator assembly.
- Disconnect the electrical connector to the motor and unbolt the motor/regulator mounting points.
- Support or secure the glass while releasing the regulator from the window channel to prevent glass drop or damage.
- Install the new motor/regulator assembly, reconnect the wiring, and test window operation before reassembling the door trim.
- Check and lightly lubricate regulator tracks and sliders with suitable plastic-safe grease to extend service life.
Installation Recommendations
- Always disconnect the battery prior to door electrics work and follow manufacturer safety procedures.
- Test the new unit for full travel and correct direction before refitting the door card.
- Use correct fasteners and torque settings where specified; ensure the glass is properly seated in the regulator clamps.
- Inspect the window switch, fuses and wiring for damage when diagnosing to avoid replacing the motor unnecessarily.
Most Common Failure Reasons
- Wear Of Internal Gears And Motor Brushes Causing Reduced Torque Or Intermittent Operation.
- Moisture Ingress Leading To Corrosion Of Mechanical Parts Or Electrical Connectors.
- Broken Or Stretched Regulator Cables And Worn Sliders Causing Binding And Extra Load On The Motor.
- Impact Or Forced Operation (e.g., obstructed glass) Leading To Mechanical Damage.
Technical Information
- Manufacturer: Stellantis / Peugeot / Citroën
- Model: Peugeot 3008 I, Peugeot 5008 I
- Product Codes: 9682808780, 1607675380, 9223F2
- Other Numbers: (T84), (T87)
- Position: Rear Left (Driver-Side Rear)
Notes For Mechanics And DIYers
When fitting this part, verify mechanical smoothness of the regulator and ensure the glass runs freely in its guides. Replacing the motor alone without checking regulator integrity may lead to premature recurrence of the fault. Keep door seals and drainage channels clear to reduce moisture-related failures.
Search Tips
Customers commonly search by part numbers 9682808780, 1607675380 and 9223F2 or by vehicle model (Peugeot 3008, Peugeot 5008). Including these references in listings increases findability and speeds up correct part selection.
