Description
Electric window regulator for Peugeot 3008 and 5008 first generation. Front passenger door.
Product Overview
This electric window regulator is intended for the front passenger door of first-generation Peugeot 3008 and 5008 models. It includes the motor and mechanical regulator assembly designed to restore smooth, reliable glass movement. Commonly searched by OEM codes 9682808880 and 9222FF, this part is suitable for professional workshops and experienced DIY technicians who perform body and door repairs.
Key Features
- Direct-fit replacement for Front Passenger Door on Peugeot 3008 I and Peugeot 5008 I.
- Complete assembly: motor plus regulator mechanism for easy swap-and-go replacement.
- OEM Cross-references Included: 9682808880, 9222FF — often used when searching by part number.
- Designed to restore original window travel, noise level and speed when installed correctly.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 3008 I, Peugeot 5008 I (First Generation)
- Product Codes: 9682808880; 9222FF
- Additional Numbers: 9222.FF (alternative notation)
Installation Recommendation
- Always disconnect the vehicle battery before starting work to prevent electrical short circuits and to protect the control electronics.
- Remove the door trim panel carefully, taking care with clips and wiring harnesses. Keep screws and clips organized for reassembly.
- Disconnect the electrical connector from the window motor and unbolt the regulator assembly from the door shell. Support the glass to prevent dropping; lower or raise the glass to access mounting points if needed.
- Transfer any required guide clips or brackets from the old regulator if they are not supplied with the new unit. Fit the new regulator, secure bolts to manufacturer torque where available, reconnect the motor connector and test operation before refitting the door panel.
- Check window travel and alignment, lubricate guides and contact points with appropriate grease, and ensure there are no rubbing or binding points on the glass.
- Recommended For: Professional installation or experienced DIY mechanics with basic door-trim removal experience and standard hand tools.
Common Failure Causes
- Wear Of Mechanical Components: Plastic sliders, guides and cable systems degrade over time and can break or jam.
- Motor Wear Or Electrical Issues: Repeated use, contamination or moisture ingress can reduce motor performance or cause complete failure.
- Water Ingress And Corrosion: Door seals and drainage failures allow moisture to reach the regulator and connections, accelerating wear.
- Obstruction And Misalignment: Blocked tracks or misaligned glass increases load on the motor/regulator leading to early breakdown.
- Typical Onset: Failures usually occur after several years of service depending on climate, frequency of use and maintenance; harsh environments and heavy use shorten component life.
Practical Tips
- Before replacing the regulator, confirm fuses and switch operation to rule out simple electrical faults.
- If the motor still runs but movement is intermittent, inspect guides and drains for blockage—repairing the track can extend the life of a new regulator.
- When fitting, test the window through full travel several times and verify the door lock and anti-pinch functions (if equipped) operate correctly.
Why Choose This Part
Replacing a faulty window regulator with a correct-fit unit specified by part numbers 9682808880 or 9222FF ensures restored functionality, quieter operation and reliable sealing of the door. The unit is optimised for Peugeot 3008 and 5008 first-generation front passenger doors and improves diagnostics and service time for professional garages.
