Description
Parking Assistance Wiring Harness
Rear Bumper
From Peugeot 5008, Year 2011
Description
This parking sensor (PDC) wiring harness is designed for the rear bumper of the Peugeot 5008. It connects the ultrasonic parking sensors to the vehicle’s parking assistance module, supplying power, ground and signal lines. Ideal for professional workshops and DIY mechanics searching by product codes 9688709180 or 65280A, this harness restores reliable communication between sensors and the control unit after damage or wear.
Key Features
- Direct fit for rear bumper parking sensor systems.
- Includes connector plugs and pre-formed routing for factory mounting points.
- Designed to withstand automotive vibration and typical under-bumper exposure.
- Often searched and ordered using OEM codes 9688709180 and 65280A.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 5008 (First Generation) – 2011
- Product Codes: 9688709180, 65280A
- Additional Numbers: 65280A | 9688709180
How It Works
The harness routes power, ground and sensor signals from each ultrasonic sensor mounted in the rear bumper to the parking assistance control unit. Proper wiring ensures accurate distance measurement and reliable activation of audible/visual warnings when reversing.
How To Replace
Replacement requires basic electrical and trim removal skills. Typical steps:
- Disconnect Battery Before Starting.
- Remove Rear Bumper Trim/Fasteners To Access Sensor Area.
- Unplug Sensor Connectors And Detach Old Harness From Clips And Brackets.
- Route New Harness Following Factory Routing, Secure With Clips, And Reconnect Sensor Plugs.
- Refit Bumper Trim And Reconnect Battery.
- Verify Sensor Operation Using The Vehicle’s PDC Test Function Or By Driving Slowly Towards Obstacles.
Installation Recommendations
- Always disconnect the battery before disconnecting or connecting electrical components.
- Use dielectric grease on connectors to improve water resistance and prevent corrosion.
- Ensure harness is secured away from sharp edges, exhaust heat and moving parts.
- Check sensor connector pins for corrosion or bending before assembly.
- After installation, confirm proper operation of all sensors and clear any fault codes if present.
Most Common Failure Reasons
- Moisture Ingress And Corrosion Of Connector Pins Leading To Intermittent Or Lost Signals.
- Physical Damage From Rear Impacts Or Bumper Removal/Installation Errors.
- Rodent Damage Or Chafing From Improper Harness Routing.
- Connector Fatigue From Repeated Disconnects Or Poor Contacts.
Useful Notes
There Is No Defined Service Interval For Wiring Harnesses; Failures Are Usually Caused By External Damage Or Corrosion. Many Customers Search Using The OEM Codes 9688709180 Or 65280A — Including These Numbers In Your Search Will Improve Findability.
