Description
Left front window regulator mechanism for PEUGEOT 207. Electric window lifter for driver’s door. 6-Pin.
Product Overview
This electric left front window regulator for the Peugeot 207 is a direct-fit replacement for the driver’s door assembly. Designed for workshop and DIY use, the unit includes the motor and regulator mechanism and interfaces via a 6-pin electrical connector. Ideal for mechanics and car owners searching by part number (967120980, 9221FT), this spare part restores smooth, reliable window operation and eliminates rattles, slow movement or complete failure of the driver-side window.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 207
- Product Codes: 967120980, 9221FT
- Additional Numbers: 6-Pin Connector
Compatibility
Fits Peugeot 207 models (driver/left front). Typically used across Peugeot 207 body variants—hatchback and similar configurations—produced in the common model years. Always verify the part numbers shown on the old unit before installation.
Function And Typical Failure Modes
The window regulator assembly converts motor rotation into vertical movement of the glass, guiding and supporting the window within the door frame. Common reasons for failure include:
- Wear or breakage of plastic gears or sliding components leading to loss of drive or irregular movement.
- Cable fraying or derailment in cable-type regulators causing the glass to drop or jam.
- Motor burnout due to age, excessive load or water ingress/corrosion.
- Accumulation of dirt, corrosion or seized guides producing slow or noisy operation.
Replacement Procedure (Summary)
Recommended for experienced DIYers and professional technicians. Typical replacement steps:
- Disconnect the negative battery terminal before starting work to avoid short circuits.
- Remove the interior door trim and any vapor barriers carefully to access the regulator.
- Support the glass in the up position (use tape or a suitable prop) and disconnect the 6-pin electrical connector.
- Unbolt the regulator and motor assembly from the door and remove the unit with the glass as required.
- Install the new regulator, secure mounting points, reconnect the electrical connector and reassemble the door trim.
- Reconnect the battery and cycle the window several times to verify smooth operation and correct alignment. Lubricate guides as needed.
Installation Recommendations
- Always disconnect the battery before removal and fitment to prevent electrical damage and accidental motor activation.
- Handle glass carefully and support it during removal and installation to avoid breakage or misalignment.
- Inspect door wiring, connector pins and door guide channels for corrosion or damage and clean/lubricate before final assembly.
- After installation, check window travel limits and ensure the switch operation is smooth; adjust glass position if binding occurs.
Why The Part Most Commonly Fails
The most frequent causes are mechanical wear of plastic components and cable systems, plus motor degradation from long-term use or water ingress. Repeated stopping against obstructions (ice, debris) or worn guides increases motor load and accelerates failure. Preventive maintenance—cleaning and lubrication of guide channels and prompt repair of damaged seals—extends service life.
Notes For Buyers
If you are searching by part number, use codes 967120980 or 9221FT to find the correct left front window regulator for Peugeot 207. This unit is intended as a replacement part for the driver-side door and is supplied with the motor and regulator assembly compatible with a 6-pin electrical connector.
