Power Management Fuse Module Peugeot 508 9665878080

€97.00

Stellantis Citroën Peugeot
9665878080

1 in stock

SKU: 9931-S6_K39 Categories: , , Tag:

Description

Protection and Power Management Unit for Peugeot 508

This used Power Distribution and Fuse Module (BSM) for the Peugeot 508, part number 9665878080, controls and protects multiple electrical circuits in the engine bay. It consolidates fuses, relays and power-management functions into a single unit, reducing wiring complexity and providing overcurrent protection for critical systems such as engine management, ignition, cooling fans and charging circuits. Ideal for professional workshops and experienced DIY mechanics looking for a direct replacement part identified by OE number 9665878080.

Function And Application

The module serves as the central power distribution point in the engine compartment, managing supply to fuel system components, ignition, sensors and various ancillaries. When healthy, the unit routes current through fuses and relays while isolating faults to protect wiring and electronics. Replacement of a faulty module restores reliable power distribution and eliminates intermittent electrical failures originating from the engine bay fuse area.

Technical Information

  • Manufacturer: Stellantis (Citroën / Peugeot)
  • Model: Peugeot 508
  • Product Codes: 9665878080
  • Other Numbers: Not Listed

Installation Recommendations

  • Always disconnect the negative battery terminal before starting work to avoid short circuits and protect electronic components.
  • Work in a dry environment; remove any engine covers and secure access to the module mounting screws and electrical connectors.
  • Carefully unclip and release all wiring harness connectors—do not force connectors to avoid breaking locking tabs. Note connector orientation for correct reassembly.
  • Inspect mating connectors and wiring for corrosion or heat damage; clean or repair any suspect terminals before fitting the new module.
  • Fit the replacement unit, tighten mounting fasteners to the vehicle manufacturer’s torque recommendations, reconnect connectors and then the battery.
  • After installation, clear stored fault codes and verify system operation with a diagnostic tool. Check lights, engine start, charging system and any functions previously affected.

How The Module Is Replaced

Typical replacement is a straightforward mechanical swap in the engine bay: disconnect battery, remove any protective covers, unplug harnesses, unbolt the module, transfer seals/grommets if required, fit the new unit and reconnect. Final checks with a diagnostic scanner are recommended to ensure all circuits are operational and no residual faults remain.

Why This Part Fails Most Often

  • Water Ingress And Corrosion: Moisture penetration into the engine bay can corrode terminals and PCB traces inside the module.
  • Thermal Stress: Repeated heating and cooling cycles can weaken solder joints, relays and connector contacts.
  • Electrical Overload Or Short Circuits: Undetected shorts or a recurring overload can damage internal protection devices or tracks.
  • Poor Connector Contact: Loose or oxidised connector pins create intermittent faults and increased resistance, leading to local heating and failure.

Notes For Mechanics And DIYers

Search and order by OE number 9665878080 to ensure correct fitment. Because the BSM is located in the engine bay, inspect surrounding seals and splash protection when replacing the module to prevent repeat failures. If multiple circuits are affected or faults reappear after replacement, inspect wiring harnesses, relay sockets and downstream components for underlying causes before fitting a second unit.

Additional information

Weight 1.2 kg

Unless otherwise specified in the description, all photos are for illustrative purposes only.

We reserve the right to replace the ordered reference with the manufacturer's replacement reference.

The parts come from crashed vehicles, are carefully inspected, and we provide a 12-month warranty on functionality for them.