Description
Right rear lamp for Peugeot 206 3/5-door vehicles. Up to production date 06/2003. Passenger side.
This high-quality replacement rear lamp is designed for Peugeot 206 3-door and 5-door models produced until June 2003. Ideal for professional mechanics and DIY enthusiasts, the assembly restores full rear lighting functionality including tail/position, brake and indicator signals (reverse or fog functions depend on variant). Supplied as a direct-fit unit for the passenger side, it matches original mounting points and electrical connectors to simplify installation and reduce workshop time. Part number 6351P1 is commonly used when searching for a compatible lamp.
Key Benefits
Reliable Fitment: Direct replacement for the original Peugeot 206 passenger-side rear lamp, designed to align with factory fixing points and connector locations.
Improved Safety: Restores full visibility for braking and signaling, keeping the vehicle road-legal and safer to drive.
Quick Replacement: Simple removal and refit procedure reduces vehicle downtime — suitable for both garage technicians and competent DIYers.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 206 (3-Door / 5-Door) — Up To 06/2003
- Product Codes: 6351P1
- Other Numbers: NFP
- Side: Right / Passenger Side
- Functions: Tail/Position Light, Brake Light, Indicator (Turn Signal); Reverse/Fog Light Function Depending On Version
- Condition: Replacement Unit (Used/New as Specified By Listing)
Installation Recommendations
Preparation: Park on a level surface, switch off ignition and remove the key. For safety, isolate the battery if you will be working near wiring or splicing connectors.
Removal: Open the boot and remove any trim panels to access the lamp fasteners. Unscrew the retaining bolts or nuts securing the lamp to the body and carefully pull the lamp assembly outwards.
Electrical: Disconnect the multi-pin connector and bulb holders. Inspect connector pins and wiring for corrosion or damage.
Fitment: Plug the connector into the new lamp, fit any bulb holders, position the lamp into the body aperture and secure with the original fixings. Refit trims and test all lamp functions (tail, brake, indicator and reverse/fog if applicable).
Finishing: Ensure the lamp gasket/seal sits correctly to prevent water ingress. Use a small amount of dielectric grease on connector pins to improve corrosion resistance where appropriate.
Common Failure Causes
Impact Damage: Rear collisions or minor bumps often crack the lens or housing, making replacement necessary.
Water Ingress: Deteriorated seals allow moisture into the assembly, causing bulbs to fail or internal corrosion of sockets and connectors.
Bulb Wear: Conventional filament bulbs have limited service life and can fail earlier than the entire assembly.
Connector Corrosion: Salt and road grime can corrode contacts, causing intermittent or non-functional lights.
Aging Plastics: UV exposure and heat cycling can cause housing deformation or seal hardening over many years.
Fitment And Compatibility
Fits: Peugeot 206 — 3-Door And 5-Door Versions Manufactured Up To June 2003.
Side: Right / Passenger Side Only.
Search Tip: The part is commonly searched by code 6351P1; include this reference when ordering to improve the chance of finding the correct match.
Additional Notes
Before completing the installation, verify that the assembly matches the vehicle variant (tail/indicator/reverse configuration). Replace bulbs with correct specification replacements if not included. After installation, perform a full function check in cooperation with an assistant to confirm brake, tail and indicator operation.
