Description
Driver Airbag For Steering Wheel – Driver For Peugeot 206. Color HZR – Gray Astrakan.
Product Overview
Used driver’s steering wheel airbag designed for Peugeot 206. This original-equipment airbag unit (part numbers 96441166ZR / 4112FW) is a direct replacement for vehicles with matching steering wheel trim and connector. Ideal for professional workshops and DIY mechanics who search parts by product code — including searches for 96441166ZR and 4112FW.
Function
The driver airbag is a primary component of the Supplemental Restraint System (SRS). In the event of a qualifying frontal impact, the module rapidly inflates to reduce driver injury by cushioning the head and chest and working together with the seat belt. The airbag assembly contains the inflator, cushion, and the electrical connector that interfaces with the vehicle SRS wiring.
Fitment
Fits Peugeot 206 models with the corresponding steering wheel and airbag connector. Common body variants include Hatchback, SW (Station Wagon) and CC (Coupe Cabriolet). Compatibility typically depends on steering wheel design and color code (HZR – Gray Astrakan). Many customers locate this part by the product codes 96441166ZR and 4112FW.
Installation Recommendations
Replacing a steering wheel airbag requires care and respect for SRS safety procedures. Follow these recommended steps:
- Disconnect the negative battery terminal and wait at least 10–15 minutes to allow the SRS capacitors to discharge.
- Remove steering wheel covers or trim to access airbag retaining fasteners (usually Torx or bolts behind trims).
- Carefully unfasten the airbag unit and disconnect the electrical connector(s). Note the connector locking tab and orientation.
- Handle the removed airbag with the pad facing upward and store it away from heat sources or electrical equipment.
- Install the new unit by reconnecting the electrical connector(s), secure the retaining fasteners to the manufacturer torque specification, and reassemble trims.
- Reconnect the battery and verify SRS warning lamp behavior. If the SRS lamp remains lit, diagnose the fault with appropriate diagnostic equipment.
Because airbag work affects vehicle safety, use proper tools and follow the vehicle manufacturer’s service manual. If unsure about procedures or fault diagnosis, seek a qualified technician.
Most Common Causes Of Failure
Driver airbag failures or removals typically result from:
- Deployment in a collision (airbag must be replaced after deployment).
- Electrical faults such as damaged wiring, corroded connectors or poor contact at the clock spring (spiral cable) which can stop the inflator circuit from working or trigger SRS warnings.
- Clock spring wear or failure causing intermittent contact to the airbag circuit.
- Physical damage to the airbag pad or connector during previous repairs or improper handling.
