Description
Window regulator mechanism for the right rear window for PEUGEOT 308 T7. Passenger-side rear door.
This high-quality replacement window regulator is designed for the right rear (passenger-side) door of the Peugeot 308 T7. It restores reliable up-and-down movement of the window glass and is identified by common OE codes used by Stellantis/Peugeot. Ideal for professional mechanics and experienced DIY technicians looking for a direct-fit solution that matches factory mounting points and electrical connectors.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 308 (T7) — Right Rear Door (Passenger Side)
- Product Codes: 9675462980, 9675462980-00, 9224E2
- Other Numbers: 9224.E2, 922400
Function
The window regulator mechanism guides and supports the glass while converting motor rotation into smooth linear movement. It keeps the window sealed and stable in any travel position and works together with the electric motor, regulator tracks or cable system, and door mounting points to provide quiet and reliable operation.
Common Failure Causes
- Wear of plastic sliders or guides causing binding and uneven movement.
- Cable fraying or snapping in cable-driven regulators.
- Corrosion or water ingress that seizes moving parts or motor.
- Broken mounting points or bent tracks from impact or forced operation.
- Electric motor wear resulting in slow, noisy, or intermittent operation.
Symptoms That Indicate Replacement Is Needed
- Window moves slowly, jerks, or gets stuck during travel.
- Unusual grinding, clicking, or whining noises from inside the door.
- Window drops down or will not stay in position.
- Complete failure to move the window despite power at the switch.
Installation Recommendations
Replacement can be performed by a competent technician or an experienced DIYer with basic automotive tools. Follow these general steps and always refer to vehicle service information where available:
- Disconnect the vehicle battery before starting work to avoid accidental operation and short circuits.
- Remove the interior door trim and any clips, and carefully peel back the vapor/water barrier.
- Support the window glass (tape or suction support) and, if necessary, partially lower it to access mounting bolts.
- Disconnect the electrical connector for the window motor and unbolt the regulator and motor assembly from the door and glass.
- Remove the old regulator, transfer any reusable parts if required, and fit the new regulator in the reverse order.
- Align the glass, secure mounting points, reconnect the motor and battery, then test the window operation through full travel before reassembling the door trim.
- Ensure clips and seals are refitted correctly to maintain door sealing and NVH performance.
Why This Part Fails Most Often
Window regulators are subject to continuous mechanical stress and environmental exposure. Plastic sliders and cable systems wear over time, and moisture ingress accelerates corrosion and motor degradation. Frequent stop-start use, forcing the window when jammed, or water accumulation inside the door are common causes of premature failure.
Notes
Supplied OE numbers: 9675462980 / 9675462980-00 / 9224E2. Confirm fitment by comparing these codes with the existing part numbers listed on the vehicle part. Installation requires careful handling of the glass and electrical connector; when in doubt, have the replacement carried out by a professional workshop.
