Description
Right-Rear Window Regulator Motor-Reducer for PEUGEOT 308 T7. Rear Passenger-Side Door.
This replacement motor-reducer restores reliable electric operation of the right rear (passenger-side) window on Peugeot 308 (T7). Designed as a direct-fit power-window motor with integrated gearbox, it delivers the torque and gear reduction required to move the window glass smoothly under load. Ideal for professional workshops and experienced DIY technicians searching by OE numbers (9680617480, 9675466680, 9224F0, 0130822448, 130822448), this unit helps eliminate slow, noisy or non-functioning rear window operation and returns factory-like performance.
Technical Information
Manufacturer: Stellantis (Citroën/Peugeot)
Model: Peugeot 308 (T7) – Right Rear / Rear Passenger Door
Product Codes: 9680617480, 9675466680
Other Numbers: 0130822448, 9224F0, 130822448
Function And Typical Symptoms
The unit is an electric 12V motor with an integrated gear reduction that drives the window regulator mechanism. Common symptoms of a failing motor include clicking noises, slow or intermittent movement, jerky travel, a window that won’t move or drops down, and abnormal grinding or whining sounds. Before replacing the motor, confirm electrical supply, fuses, and switch operation to rule out wiring or control faults.
How The Part Is Replaced
General replacement procedure for experienced technicians: remove the interior door trim to access the regulator assembly, position the window to reach the motor fasteners, disconnect the electrical connector, unbolt the motor from the regulator, fit the new motor and secure fasteners, reconnect the connector and briefly test operation before reassembling the door panel. Align the regulator and ensure smooth travel throughout the full window stroke before final assembly.
Installation Recommendations
- Disconnect the vehicle battery before starting work to prevent short circuits and unintended operation.
- Support the window glass during motor removal to avoid dropping or misalignment.
- Inspect the regulator rails, sliders, cables and mounting points; replace or lubricate worn components to prevent premature motor overload.
- Test the new motor and full window travel before refitting door trim. Verify smooth upward and downward travel under load.
- Use correct tools and avoid overtightening fasteners that could damage the plastic gearbox housing.
Most Common Failure Causes
Failures are typically caused by water ingress and corrosion, worn commutator brushes, stripped or fatigued gearbox teeth, and excessive mechanical resistance from a seized or misaligned regulator. Repeated heavy use, accidental damage to the door area, or contaminated drainage holes can accelerate wear and lead to early failure.
Notes For Professionals
When replacing the motor, check the regulator mechanism for binding or excessive play. Addressing regulator issues at the same time prevents rework and extends the life of the new motor. This part is intended primarily for use on Peugeot 308 (T7) right rear doors and is commonly searched by OE numbers listed above.
