Description
Instrument cluster for Peugeot 307 II. Removed from a vehicle with approximately 249,000 km.
Description
High-quality used instrument cluster (tachometer and dashboard cluster) originally fitted to Peugeot 307 II. The unit displays speed, engine RPM, fuel level, coolant temperature and odometer information. Supplied as a complete dash module removed from a vehicle with about 249,000 km; ideal for mechanics and DIY enthusiasts looking for a direct replacement by product code.
Key Features
- Direct-fit replacement for compatible Peugeot 307 dashboards.
- Includes odometer display and all standard gauge functions (speedometer, tachometer, fuel, temperature).
- Supplied with original electronics and connectors—product codes included for easy identification.
- Great option for repairs where OEM-coded clusters are required by matching part numbers.
Compatibility & Fitment
Primarily Intended For: Peugeot 307 II. Compatibility is typically determined by matching the product codes listed below. Commonly fitted to petrol and diesel variants of the 307 II depending on the vehicle specification and wiring harness.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 II
- Product Codes: 9660470680, P9660470680, P9660470680 E01
- Additional Numbers: 6103L6, 6105T2
Typical Failure Modes — Why Clusters Fail
- Worn or failing stepper motors that drive analogue needles, causing inaccurate or stuck gauges.
- Poor solder joints or cracked traces on the circuit board, often due to thermal cycling and age.
- Faulty or dim LCD/LED odometer segments and backlighting issues.
- Connector corrosion or damaged wiring leading to intermittent signals or total loss of function.
- Electrical surges, water ingress, or long-term exposure to moisture can damage components.
How To Replace (General Procedure)
- Disconnect the negative battery terminal before starting to avoid short circuits and protect vehicle electronics.
- Remove the dashboard trim pieces and bezel surrounding the cluster—usually held with clips and a few screws.
- Unscrew the instrument cluster retaining screws and tilt the unit forward carefully.
- Disconnect the multi-pin connectors on the rear of the cluster. Take note of connector positions and locking tabs.
- Fit the replacement cluster by reversing removal steps. Reconnect the battery only after the cluster is secured and connectors are fully seated.
- After installation, cycle the ignition and verify all gauges, warning lights and the odometer operate correctly.
Installation Recommendations
- Always Disconnect The Battery: Before any dashboard work, disconnect the negative battery terminal to prevent damage to the instrument cluster and vehicle electronics.
- Handle With Care: Avoid touching the circuit board or LCD segments; static discharge or pressure can damage components.
- Inspect Connectors: Clean and inspect all wiring plugs and harnesses—corroded pins should be cleaned or replaced to ensure reliable operation.
- Retain All Fasteners And Clips: Use the original screws and trim clips to ensure proper fit and to avoid rattles.
- Calibrate If Needed: Some vehicle configurations may require final checks or recalibration after replacement—follow manufacturer procedures where applicable.
Why Choose This Unit
This instrument cluster is a practical solution for garages and hobby mechanics needing a cost-effective, direct-fit replacement by part number 9660470680 (also referenced as 6103L6 / 6105T2). It preserves original dashboard functionality and avoids the higher cost and wait time of new OEM units. Supplied as removed from a vehicle with known mileage, enabling quick identification of wear and expected service life.
Purchase Information
If your vehicle uses the product codes listed above and your cluster shows intermittent gauges, dead backlight, or a failing odometer display, this unit can restore full dashboard functionality. Order now to replace a faulty cluster and get your Peugeot 307 back on the road.
