Description
Speaker for Citroën and Peugeot vehicles. Diameter 165 mm.
Overview
OEM-style replacement speaker compatible with a range of Citroën and Peugeot models. Supplied under part references 9665245180 and 6562X2, this 165 mm (approx. 6.5″) loudspeaker is intended for technicians and experienced DIY installers who need a direct-fit unit to restore factory audio performance. Common search terms: Citroën speaker 9665245180, Peugeot 6562X2, 165 mm car speaker, replacement door speaker.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C2; Citroën C3; Citroën C3 Pluriel; Citroën C4 II; Citroën C4 Picasso; Peugeot 3008 I; Peugeot 308; Peugeot 5008 I
- Product Codes: 9665245180, 6562X2
- Additional Numbers: N/A
Fitment And Application
The 165 mm diameter makes this speaker suitable as a direct replacement in door or factory speaker locations on the listed Citroën and Peugeot models. Exact installation position (front door, rear door, or dash) depends on vehicle trim and original equipment layout. This part is typically used where the original OEM speaker size is 165 mm.
Installation Recommendations
Recommended for professional installers and competent DIYers. Basic installation steps:
- Prepare: Park the car on a level surface and disconnect the negative battery terminal to avoid short circuits while working on vehicle electrics.
- Access: Remove the door trim panel or speaker grille following the vehicle manufacturer’s procedure to avoid damaging clips and wiring.
- Remove Old Unit: Unscrew the original speaker, carefully unplug the speaker connector and note any spacers or adapters used.
- Fit New Speaker: Transfer any necessary mounting brackets or gaskets, connect the speaker harness, and secure the new speaker with the original fixings.
- Test: Reconnect the battery and test the speaker at low volume to confirm correct polarity and operation before reassembling the door trim.
- Finish: Refit the trim and confirm all clips and screws are secured.
Common Failure Causes
Car speakers typically fail due to mechanical wear and environmental exposure rather than a fixed service interval. Typical causes include:
- Cone or foam surround deterioration caused by age and UV exposure.
- Water ingress from door seals or window channels leading to corrosion or voice coil damage.
- Blown voice coil from prolonged high-volume use or amplifier faults.
- Connector corrosion or broken wiring affecting signal delivery.
- Physical damage from improper removal/installation or impact.
Why Choose This Part
This speaker is offered as an OEM-compatible replacement referenced by common part numbers used by Citroën and Peugeot owners and workshops. It provides a straightforward route to restore audio clarity and balance without the need for custom adapters, saving fitment time for mechanics and confident DIYers. Always confirm the speaker size and mounting pattern on the vehicle before purchase to ensure a correct fit.
Notes For Mechanics And DIYers
Part numbers are frequently used when sourcing replacement speakers. Searching for 9665245180 or 6562X2 will help locate the exact item. Keep original mounting hardware and observe correct speaker polarity during installation to avoid phase issues. If the vehicle has an upgraded audio system or amplifier, verify compatibility to prevent overloading or underpowering the new speaker.
