Description
Accelerator pedal BOSCH for Peugeot 206 vehicles.
High-quality Bosch Accelerator Pedal designed for Peugeot 206 and compatible Stellantis models. Precision-built electronic pedal restores accurate throttle response and driveability for vehicles with electronic throttle control. Ideal for professional workshops and experienced DIY mechanics who frequently search by part number: 0280755074, 9659449880, 1601T1. OEM-Grade Construction Ensures Reliable Signal Transmission To The Engine Control Unit And Stable Pedal Feel Under Load.
Technical Information
- Manufacturer: Bosch
- Model: Accelerator Pedal / Throttle Pedal Sensor
- Product Codes: 0280755074, 9659449880, 1601T1
- Additional Numbers: 1601.T1, 280755074, 280755074 (alternative reference)
Fitment
Primary Fitment: Peugeot 206. May fit other Citroën/Peugeot models that share the same throttle pedal assembly and part numbers—check compatibility by comparing product codes. This unit Is Commonly Referred To By Its Part Number In Search Queries.
Function And Operation
This electronic accelerator pedal (drive-by-wire) converts the driver’s pedal movement into an electrical signal that is sent to the Engine Control Unit (ECU). The ECU Uses This Signal To Control Throttle Opening, Ensuring Smooth Acceleration, Fuel Efficiency, And Driveability. The Pedal Contains Position Sensors (Potentiometer/Hall Sensors) And A Return Mechanism To Provide Accurate And Repeatable Feedback.
Installation Recommendations
- Safety First: Disconnect the battery before starting the job and follow the vehicle manufacturer’s procedure to avoid damage to electronic components.
- Access: Remove the lower dash/footwell trim to reach the pedal assembly. Take care with plastic clips and retainers.
- Disconnect: Unplug the electrical connector by releasing the locking tab. Inspect the connector for corrosion or damaged pins.
- Removal: Remove mounting bolts securing the pedal assembly. Note the orientation and any shims or spacers used.
- Installation: Fit the replacement pedal, secure bolts to the original mounting points, and reconnect the electrical connector. Ensure wiring is routed clear of moving parts and heat sources.
- Post-Installation: Clear any stored fault codes. Throttle adaptation or relearn may Be Required—perform with a diagnostic tool or follow the vehicle-specific procedure to ensure correct idle and throttle response.
- If You Are Unsure: Have The Procedure Performed By A Qualified Technician With Suitable Diagnostic Equipment.
Why This Part Most Often Fails
- Sensor Wear: Internal potentiometers or Hall sensors can wear with age and high mileage, causing erratic signals or loss of continuity.
- Contamination And Moisture: Dirt ingress, water, or corrosion at the connector or inside the assembly can lead to intermittent faults.
- Mechanical Damage: Impact, snapped mounting points, or a broken return spring will affect pedal travel and function.
- Electrical Issues: Damaged wiring or poor connector contact can produce fault codes and loss of throttle signal.
- Typical Occurrence: Failures Are More Common On Higher-Mileage Vehicles Or After Exposure To Moisture/Physical Damage.
Practical Tips For Workshops And DIY Mechanics
- Always Compare Part Numbers (0280755074 / 9659449880 / 1601T1) Before Fitting To Confirm Correct Replacement.
- Inspect Wiring Harness And Connector Pins During Replacement—Repair Any Corrosion Or Damaged Wires To Prevent Recurrence.
- After Replacement, Check For Engine Management Faults And Perform Any Required Throttle Relearn Procedures To Avoid Limp Mode Or Hesitation.
Common Search Terms
Bosch Accelerator Pedal 0280755074, Peugeot 206 Throttle Pedal 9659449880, 1601T1 Throttle Pedal Sensor, Drive-By-Wire Pedal Peugeot.
