Description
Bosch Accelerator Pedal for Peugeot 206
Product Overview
High-quality Bosch accelerator (throttle) pedal assembly designed for Peugeot 206 vehicles. This electronic pedal converts driver input into an electrical signal for the engine control unit, ensuring precise throttle response and smooth drive-by-wire operation. Ideal for professional garages and skilled DIY mechanics looking for a direct replacement using original equipment (OE) reference numbers.
Key Features
- Direct replacement for OE-coded accelerator pedals, matching electrical and mechanical interfaces.
- Integrated position sensor (potentiometer or Hall-effect type depending on production variant) with robust housing and connector.
- Improved response and reliability when replacing a worn or faulty pedal sensor.
- OE cross-reference numbers included for fast searchability and part matching.
How It Works
The accelerator pedal assembly measures the pedal travel and sends a proportional electrical signal to the engine control unit (ECU). The ECU then determines throttle opening (electronic throttle body) or fuel/torque request depending on vehicle calibration. Because the unit is an electronic sensor, correct electrical connection and secure mounting are essential for accurate operation.
Typical Failure Modes
Electronic accelerator pedals generally do not have scheduled replacement intervals. Failures usually result from:
- Wear of the sensor elements (potentiometer contact wear) or degradation of Hall sensors over time.
- Corrosion or contamination of electrical connector pins from moisture or road debris.
- Mechanical damage from improper handling, impact, or interior maintenance work.
- Intermittent signals caused by damaged wiring or poor connector seating.
Installation Recommendations
- Always disconnect the vehicle battery before removing or installing the pedal assembly to avoid short circuits and unintended actions.
- Remove dash trim or footwell covers as required to access the pedal mounting points and electrical connector.
- Unplug the electrical connector and remove the mounting bolts/screws holding the pedal module. Keep fasteners and any spacers for reassembly if applicable.
- Install the new pedal in the reverse order, ensuring the connector is fully seated and clips/locks engage securely.
- After installation, check for diagnostic trouble codes and clear them if necessary. Perform throttle adaptation or calibration if required by the vehicle—use diagnostic equipment for best results.
- Avoid excessive force on the sensor body and wiring; inspect connector pins for corrosion and clean if needed before installation.
Why Replace This Part
Replace the accelerator pedal when you observe symptoms such as erratic idle, loss of throttle response, throttle-related warning lights (e.g., throttle pedal sensor or engine management warnings), or when diagnostics show inconsistent pedal position signals. Timely replacement restores predictable throttle control and prevents drivability issues.
Technical Information
- Manufacturer: Bosch
- Model: Peugeot 206
- Product Codes: 0280755026, 9654877480, 1601Q2
- Additional Numbers: 280755026, F00C3E2429
Fitment
Designed for Peugeot 206 models. Ensure the OE/product code matches your vehicle application before ordering.
Notes for Professionals
This part is suited for automotive technicians and experienced DIY installers. Use proper diagnostic tools to verify signal integrity and perform any required throttle adaptations after replacement. Observing correct installation procedures will reduce the risk of faults and restore reliable drive-by-wire operation.
