Description
Electric central locking lock for the right rear door for Citroën Xsara Picasso vehicles. Rear Passenger-Side Door.
Product Overview
High-quality electric door lock designed for the right rear (passenger-side rear) door of the Citroën Xsara Picasso. The unit operates as part of the vehicle’s central locking system, engaging and releasing the latch via an integrated actuator. This replacement part is commonly searched by its OEM reference number 913894.
Key Benefits
- Direct Fit Replacement For Citroën Xsara Picasso Right Rear Door
- Restores Central Locking Function And Door Security
- Ideal For Mechanics And Skilled DIY Enthusiasts
- Easy-To-Follow Installation Steps For Faster Workshop Turnaround
Technical Information
- Manufacturer: Stellantis / Citroën
- Model: Citroën Xsara Picasso — Right Rear Door (Passenger-Side Rear Door)
- Product Codes: 913894
- Additional Numbers: N68, NFP
Function And Typical Faults
The unit combines a mechanical latch and an electric actuator to lock/unlock the door as part of the central locking system. Common failure modes include motor or gear wear inside the actuator, corrosion and water ingress into the mechanism, broken plastic components, and wiring or connector faults caused by repeated door opening/closing and cable flexing.
Why This Part Fails Most Often
- Water Ingress And Corrosion: Moisture entering the lock assembly leads to rusted linkages and impaired electrical contacts.
- Mechanical Wear: Plastic gears and small mechanical components degrade over years of use or after heavy/slammed closures.
- Wiring Damage: Cable harness fatigue at the door hinge area or connector corrosion can interrupt power to the actuator.
- Impact Or Misalignment: Door alignment issues or impacts can stress the lock mechanism and accelerate failure.
Installation Recommendations
Intended For Use By Professional Technicians Or Experienced DIYers. Recommended Tools: Torx/Phillips set, trim removal tools, multimeter, lubricant (dry or white lithium), and small torque wrench for fasteners.
- Safety First: Disconnect The Battery Before Starting Work To Avoid Short Circuits Or Damage To Electrical Components.
- Remove Interior Door Trim Carefully To Access The Lock Assembly. Use Trim Tools To Avoid Breaking Clips.
- Detach Electrical Connector And Any Linkages Or Rods Attached To The Lock. Note Orientation And Routing For Reassembly.
- Remove Mounting Bolts And Extract The Old Lock Assembly. Inspect Surrounding Door Structure For Corrosion Or Damage.
- Transfer Any Required Linkages Or Clips To The New Unit If Necessary, Then Fit The New Lock And Tighten Fasteners To Manufacturer Guidelines.
- Reconnect Electrical Connector, Reattach Rods/Linkages, And Test Locking/Unlocking Function Before Reassembling Door Trim.
- Lubricate Moving Parts Lightly With An Appropriate Grease And Check Door Alignment If Locking Is Not Smooth.
Practical Tips
- Check Wiring Continuity With A Multimeter If The Actuator Does Not Respond; Faults Often Occur In The Door Harness Near The Hinges.
- If The Mechanism Shows Signs Of Water Damage, Inspect And Seal Any Door Panel Drainage Holes And Protective Foil.
- Replace Fasteners Or Broken Clips During Reassembly To Ensure Panel Fit And Prevent Rattles.
Compatibility Notes
Fits Citroën Xsara Picasso models requiring OE Part Number 913894 for the Right Rear (Passenger-Side Rear) Door. Product is typically referenced by code 913894 or tag N68/NFP in parts lists and catalogs.
Final Advice
When replacing a door lock, test the entire central locking circuit after installation (remote key operation, interior lock switches, and mechanical manual operation). Proper diagnosis of the root cause (electrical vs. mechanical) avoids repeated replacements. For workshop installations, follow manufacturer service procedures and torque settings where available.
