Description
Electric central locking lock for the right front door of the PEUGEOT 407 (passenger side).
Designed for professional workshops and DIY mechanics, this direct-fit electric door lock/actuator restores reliable central locking operation on the right front (passenger) door of the Peugeot 407. The part is commonly referenced by the codes shown below, which technicians often use when searching for a replacement. The unit replaces a failed actuator to recover door locking, remote locking response and passenger-side security.
- Direct replacement for the right front (passenger) door of Peugeot 407.
- Restores central locking function and remote locking reliability.
- OE-style electrical connector and mounting points for straightforward installation.
- Commonly searched under product numbers to simplify procurement and fitment.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 407 — Right Front Door (Passenger Side)
- Product Codes: 9660698180
- Other Numbers: F00, 9136FE, 9136CK
How To Replace
Replacement can be performed in a moderately equipped workshop. Typical procedure:
- Disconnect the negative battery terminal or ensure ignition and accessories are off to prevent short circuits.
- Remove the inner door trim panel using appropriate trim tools to avoid damage to clips and upholstery.
- Peel back the moisture barrier carefully to access the lock assembly.
- Disconnect the electrical connector from the actuator and unhook any linkage rods connecting the lock to the door handle/latch.
- Remove the fasteners securing the lock/actuator unit and extract the old part from the door.
- Install the new actuator, refit fasteners, reconnect linkage rods and the electrical connector, then test the central locking operation before reassembling the door trim.
- Reinstall the moisture barrier and door trim, ensuring all clips and screws are secured.
Installation Recommendations
- Use a set of trim tools to avoid breaking plastic clips and scratching trim pieces.
- Keep the door wiring harness and connector clean and dry; apply dielectric grease to electrical contacts if exposed to moisture.
- When testing, cycle the central locking several times to confirm smooth actuation and correct linkage geometry before final reassembly.
- Retighten fasteners to the manufacturer’s torque where specified and avoid overtightening plastic components.
Most Common Cause Of Failure
- Water ingress and corrosion inside the actuator or its connector, leading to electrical faults or seized gears.
- Wear of the small electric motor and internal gears after prolonged use, producing intermittent or failed locking action.
- Broken plastic pawls or linkage components caused by mechanical stress or forced operation of the door.
- Connector corrosion or wiring damage resulting in loss of power or erratic operation.
- Failures typically appear after several years of use or following exposure to moisture, road salt or impact to the door area.
Choosing the correct code when ordering is important — technicians frequently search by product numbers (9660698180, F00, 9136FE, 9136CK) to ensure an exact fit for the Peugeot 407 right front passenger door.
