Description
Kinetic ESP Sensor Bosch for Peugeot 307, 607, 807 and Citroën C8, Xsara Picasso
Description
This Bosch ESP kinetic sensor is designed for use on selected Peugeot and Citroën models. It supplies the vehicle stability control and ABS systems with real-time information about vehicle dynamics, enabling effective traction and stability interventions. The part is suitable for mechanics and experienced DIYers who service Peugeot 307, 607, 807 and Citroën C8 and Xsara Picasso models and who frequently search by part number (0265005290, 9650452180, 454916).
Function And Benefits
The sensor monitors kinetic parameters of the vehicle and sends measured signals to the ESP/ABS control unit. Accurate data from this sensor allow the stability system to detect understeer, oversteer and wheel slip and to apply appropriate braking or torque reduction to maintain control. Replacing a faulty sensor restores correct ESP/ABS behaviour, improves driving safety and prevents related fault codes and warning lights.
Symptoms Of Faulty Sensor
- ESP or ABS Warning Light Illuminated On Dashboard
- Intermittent Or Permanent Loss Of Traction/Stability Intervention
- Stored Fault Codes Related To Sensor Signal Or CAN Communication
- Unstable Braking Behaviour Under Low Grip Conditions
How The Sensor Is Replaced
Replacement location and access can vary by vehicle model; on many cars the ESP/kinetic sensor is mounted on the vehicle body near the center of the car (for example under the center console or close to the ABS unit). Typical replacement steps:
- Park On A Level Surface And Secure The Vehicle.
- Disconnect The Battery Before Any Electrical Work.
- Gain Access To The Sensor Location According To The Vehicle Repair Manual (remove trim panels or center console if required).
- Disconnect The Electrical Connector And Unbolt The Sensor From Its Bracket.
- Install The New Sensor, Torque Fasteners To Manufacturer Specification, Reconnect The Connector.
- Reconnect The Battery And Clear Fault Codes With A Diagnostic Tool; Verify Proper System Operation During A Test Drive.
Installation Recommendations
- Follow The Vehicle Manufacturer’s Access And Removal Procedures To Avoid Damage To Surrounding Components.
- Ensure Connectors Are Clean And Free Of Corrosion Before Reconnection.
- Use A Compatible Diagnostic Tool To Clear Fault Codes And Confirm Sensor Signals After Installation.
- Check Mounting Position And Orientation; Some Dynamic Sensors Require Correct Alignment To Function Properly.
Why This Part Fails Most Often
Common causes of sensor failure include water Ingress And Connector Corrosion, Mechanical Damage From Impacts Or Vibration, Wiring Harness Faults And Electrical Interference. Environmental Ageing And Thermal Stress Can Also Degrade Internal Electronics Over Time. Faults Often Appear As Intermittent Signals Before Complete Failure.
Technical Information
- Manufacturer: Bosch
- Model: Peugeot 307; Peugeot 607; Peugeot 807; Citroën C8; Xsara Picasso
- Product Codes: 0265005290; 9650452180; 454916
- Other Numbers: 265005290
Notes For Mechanics And DIYers
This sensor is a direct-replacement component for the listed models. When diagnosing ESP or ABS faults, inspect connectors and wiring before replacing the sensor. After replacement, perform a diagnostic scan and verify proper system operation with a short road test. Keeping the mounting area dry and securing the harness reduces the likelihood of repeat failures.
