Description
Fuel filler flap including housing for Peugeot 407. Color EXL – Obsidian Black paint. We have various colors.
This used fuel filler flap (fuel door) with its housing is a direct-fit replacement for Peugeot 407 models. It is commonly searched by product numbers 1517A7 and 151877, and is offered in EXL Obsidian Black as well as in other colors. The part is suitable for professional workshops and competent DIY mechanics looking for a cost-effective restoration of the vehicle exterior—perfect when the original flap is damaged from impacts, corrosion, or worn hinges.
Technical Information
- Manufacturer: Stellantis (Citroén/Peugeot)
- Model: Peugeot 407 (incl. Sedan / SW / Coupé range)
- Product Codes: 1517A7, 151877
- Other Numbers: EXL (Paint Code – Obsidian Black)
How To Replace
Replacement is straightforward for experienced technicians and skilled DIYers. Typical steps:
- Open the fuel flap and remove the inner trim or access panel to reach fasteners.
- Remove screws or clips holding the housing and hinge in place (keep track of fasteners and plastic clips).
- If present, unplug the locking actuator connector before removing the assembly.
- Carefully detach the flap and housing from the body, avoiding damage to surrounding paint.
- Install the new unit, align the hinge and latch, reconnect the actuator, and secure all fasteners.
- Check operation of the flap, latch engagement and (if applicable) central locking function.
Estimated labor time: approximately 0.5–1 hour depending on access and whether the locking actuator or trim must be removed.
Installation Recommendations
- Use plastic trim tools to avoid scratching surrounding paint and panels.
- Replace any damaged clips or corroded screws with new fasteners for a secure fit.
- Lubricate hinge points lightly and check the rubber seal for signs of wear; replace seal if degraded.
- When working near the painted area, protect surfaces with tape or soft cloth; touch up exposed paint to prevent corrosion.
- After installation, verify flap alignment and smooth opening/closing; adjust hinge or striker if necessary.
Common Failure Reasons
- Impact Damage: Minor collisions or knocks at the filler area commonly crack or deform the flap.
- Hinge Or Latch Wear: Plastic hinges and clips fatigue over time and can break, preventing proper closure.
- Corrosion: Rusted fasteners or body corrosion around the filler housing can seize components or cause deformation.
- Locking Actuator Faults: On models with a locking mechanism, the actuator can fail electrically or mechanically.
- Paint Damage And Chipping: Exposed metal from chips accelerates corrosion and further weakens the assembly.
Fits and fits well for mechanics and DIY repairers searching by product code (1517A7 / 151877) or by model Peugeot 407. Available in EXL Obsidian Black and other colors on request.
