Description
Right-side exterior mirror for CITROËN C4 first generation
Color KTC – Iridis paint
Electrically adjustable with temperature sensor
Passenger-side door
7 Pins (5+2)
Overview
This replacement right-hand exterior mirror is designed for Citroën C4 (first generation). It features an Iridis (KTC) finish and an electric adjustment mechanism with an integrated temperature sensor. The unit uses a 7-pin connector (arranged as 5+2) and fits the passenger-side door. Ideal for professional workshops and experienced DIY mechanics looking for a direct-fit, original-equivalent solution identified by part codes 8149ZV and 1608065580.
Technical Information
- Manufacturer: Stellantis / Citroën
- Model: Citroën C4 First Generation (C4 I)
- Product Codes: 8149ZV, 1608065580
- Other Numbers: Color Code KTC (Iridis); Connector: 7-pin (5+2)
- Side: Right (Passenger)
- Features: Electrically Adjustable, Temperature Sensor (ambient)
- Finish: LAK Iridis (KTC)
Compatible Models
Fits Citroën C4 First Generation (approx. 2004–2010), including standard hatchback variants and facelift models where the 7-pin mirror wiring and KTC Iridis finish apply. Always verify physical connector and mounting points against the vehicle prior to installation.
Function And Purpose
The exterior mirror provides driver visibility on the passenger side with electric adjustment for quick repositioning from inside the cabin. The integrated temperature sensor supplies outside temperature information used by vehicle systems. The 7-pin connector supports the mirror motor and the sensor circuits. The Iridis paint finish ensures a color-matched appearance for vehicles painted in the corresponding KTC code.
Common Failure Reasons
- Impact Damage: Collisions or knocks are the most frequent cause of mirror breakage or housing deformation.
- Water Ingress And Corrosion: Moisture can corrode connectors or motors, causing intermittent or permanent failure.
- Motor Wear: Repeated adjustment over many years can wear the internal adjustment motor or gears.
- Connector Or Wiring Damage: Pin corrosion, bent pins or chafed wiring can interrupt signals to the mirror functions.
- Sensor Failure: Temperature sensor faults may occur due to contamination or wiring issues.
Installation Recommendations
Follow these steps for a safe and reliable replacement. Recommended for professional technicians or experienced DIYers.
- Always Disconnect The Battery Before Starting Work To Prevent Short Circuits And Protect Vehicle Electronics.
- Remove The Interior Door Trim Or Mirror Access Panel To Reach The Mirror Mounting Bolts.
- Carefully Support The Mirror From The Outside While Removing Mounting Nuts To Avoid Dropping Or Damaging The Door Skin.
- Disconnect The 7-Pin Connector And Inspect Pins For Corrosion Or Damage. Clean Contacts Or Use Dielectric Grease If Appropriate.
- Fit The New Mirror, Reconnect The Connector, And Tighten Mounting Hardware To Manufacturer Torque Values. Replace Any Damaged Gaskets Or Foam Seals.
- Reconnect The Battery And Test All Functions: Mirror Adjustment, Temperature Sensor Signal (check instrument cluster/vehicle diagnostics), And Any Additional Features.
After Installation: Verify Smooth Adjustment Across Full Range And Check For Unusual Noise (Indicates Gear Or Motor Issues). If The Vehicle Has Memory Or Advanced Features, Follow Manufacturer Procedures For Function Check Or Calibration.
Why Choose This Part
Direct-fit part codes (8149ZV / 1608065580) and original-equivalent finish (KTC Iridis) make this mirror a practical replacement for workshops and DIY repairs. The integrated temperature sensor and 7-pin connector ensure compatibility with the vehicle’s electrical systems when the connector and mounting match the original equipment.
