Description
Rear Right Fog Light For Citroën C4 Picasso And Grand Picasso. Used Part, Shows Signs Of Use.
Product Description
This rear right fog lamp is a direct-fit replacement for Citroën C4 Picasso and Grand Picasso models. Supplied as a used part, it is suitable for professional workshops and self-repairing enthusiasts who search by part number (OE codes are commonly used in catalogs and search engines). The unit restores rear visibility in poor weather and meets the original mounting and electrical interface for an easy swap on compatible vehicles.
Why Buy This Part
- Direct replacement for OEM-equipped vehicles — often found by the product codes listed below.
- Cost-effective option for repairs where the original housing or connector remains serviceable.
- Easy to fit for experienced technicians and competent DIYers with basic tools.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën C4 Picasso, Citroën Grand Picasso
- Product Codes: 9653548680, 6351AA, 6351HS
- Other Numbers: NFP
Function And Common Faults
The rear fog light improves vehicle visibility to drivers behind in fog, heavy rain, or snow. Typical failure modes include bulb burnout, water ingress leading to short circuits or corrosion, cracked lens or broken mounting tabs from impacts, and connector/wiring deterioration. When a unit shows physical damage or persistent electrical faults, replacement is recommended to maintain safety and roadworthiness.
Replacement Guide
Basic steps for replacing the rear right fog lamp (general guidance — follow vehicle manufacturer procedures):
- Park the vehicle on a level surface, switch off ignition and remove the key.
- Access the lamp from the luggage compartment or by removing the rear bumper/inner trim as required by the specific model.
- Disconnect the electrical connector and remove the retaining screws or clips holding the lamp housing.
- Fit the replacement unit, secure all fasteners and reconnect the electrical connector.
- Check the function of the fog lamp and ensure correct alignment and sealing to prevent water ingress.
Installation Recommendations
- Inspect mounting points and harness connectors for damage or corrosion; replace or clean as necessary.
- Use correct torque for fasteners and ensure seals/gaskets are intact to maintain watertight installation.
- After installation, test the lamp operation from inside the vehicle and verify there are no warning lights or error messages related to the rear lighting circuit.
- When replacing bulbs, use the correct bulb type specified by the vehicle manufacturer.
Most Common Reason For Failure
The most frequent causes are water ingress and corrosion of the connector or contacts, impact damage to the lens or housing, and bulb failure. Proper sealing and careful installation significantly reduce the risk of premature failure.
Notes For Mechanics And DIYers
Customers often search using OE numbers—include part codes 9653548680, 6351AA or 6351HS when looking up compatibility. This used part is ideal when the original mounting and wiring are intact but the lamp itself is damaged or non-functional.
