Description
Left Side Mirror For Citroën C4 Vehicles, Electrically Operated. Color KTV – Paint Black Perla Nera. 7 PIN (5+2). Driver’S Door.
High-quality left (driver side) replacement mirror designed for Citroën C4 models. This electrically operated unit with a 7-pin (5+2) connector covers common functions such as mirror adjustment, heating and electric folding where fitted. Painted in KTV (Black Perla Nera) for a factory-matched finish, it is intended as a direct replacement for vehicles using the listed part codes. The mirror is an ideal choice for workshops and DIY mechanics who need a reliable, ready-to-fit spare that restores original functionality and appearance.
Technical Information
- Manufacturer: Citroën (Stellantis)
- Model: Citroën C4
- Product Codes: 96548384, 8149ZW, KTV
- Other Numbers: 8149.ZW
- Color: KTV – Black Perla Nera
- Connector: 7-pin (5+2)
- Position: Left / Driver’s Door
Installation Recommendations
Follow these steps to ensure a safe and effective replacement:
- Prepare Tools: Trim removal tools, Torx/screwdrivers as required and electrical cleaner/contact spray.
- Safety First: Disconnect the negative battery terminal before starting to prevent short circuits or accidental airbag deployment when removing door trims.
- Remove Interior Door Trim: Carefully detach door card to access the mirror mounting area and electrical connector. Use plastic trim tools to avoid damaging clips and trim.
- Disconnect Wiring: Unplug the 7-pin connector. Inspect pins and wiring for corrosion or damage before fitting the new mirror.
- Remove Old Mirror: Unscrew the mounting nuts/bolts and carefully remove the old mirror from the door aperture.
- Fit New Mirror: Position the replacement mirror, secure mounting hardware to the correct torque, and reconnect the electrical connector. Ensure connector seats fully.
- Functional Check: Reconnect the battery and verify mirror adjustment, heating and folding (if applicable) before refitting the door trim.
- Final Assembly: Refit the door card and ensure all clips and screws are secured. Perform a final function test.
Why This Part Fails Most Often
- Impact Damage: Collisions, knocks in car parks or side-swipes are the most frequent causes of broken housings, cracked glass or bent mounting points.
- Water Ingress and Corrosion: Moisture can corrode connector pins or damage the small electric motors and heating elements, leading to intermittent or complete failure.
- Motor/Wiring Wear: Repeated use over time can wear out the adjustment motor or cause wiring fatigue, especially where cables are flexed at the hinge point.
- Electrical Faults: Blown fuses, damaged connectors or poor grounding may cause loss of functions such as heating or motor movement.
Fitment Notes
Ensure the vehicle uses the same connector type and the listed part numbers prior to installation. The 7-pin (5+2) configuration typically supports mirror adjustment, heating and folding functions depending on vehicle equipment level. Test all functions before final assembly of the door trim. For painted mirrors, inspect finish for matching and handle carefully to avoid scratches during fitting.
Additional Advice For Mechanics And DIYers
This mirror is suitable for professional workshops and competent DIY mechanics. Verify functionality immediately after installation to save time on follow-up diagnostics. Keep spare mounting nuts/clips on hand, as these small parts can be damaged during removal on older vehicles.
