Description
Right Rear Tail Light for Citroën Berlingo and Peugeot Partner (Single Rear Door).
Overview
This right rear tail light is a direct replacement designed for Citroën Berlingo and Peugeot Partner models equipped with a single rear door. It is ideal for professional workshops and DIY mechanics searching by product numbers 6351J1 or 6351H2. The unit restores full rear lighting functions including parking light, stop light, indicator and reversing lamp (depending on vehicle wiring) and helps maintain legal roadworthiness and safety.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën Berlingo I & II; Peugeot Partner I & II (vehicles with single rear door)
- Product Codes: 6351J1, 6351H2
- Other Numbers: 6351J1 | 6351H2
Installation Recommendations
Follow these general steps for safe and reliable replacement. Always observe manufacturer procedures and use appropriate tools.
- Park the vehicle on a level surface, switch off the ignition and remove the key.
- Open the rear door and remove the interior trim or access panel to reach the lamp fasteners. Use trim tools to avoid damaging clips.
- Unscrew the mounting bolts (typically accessible from inside the boot area) and carefully pull the lamp unit clear of the body.
- Disconnect the electrical connector and remove the lamp assembly.
- Fit the replacement lamp, reconnect the electrical connector and temporarily secure the unit.
- Test all light functions: tail/parking, brake, indicator and reverse (if applicable). Verify correct bulb/LED operation before final tightening.
- Secure all fasteners, replace the trim panel and check alignment and sealing to prevent moisture ingress.
Recommended tools: Socket set (commonly 8–10 mm), Phillips/Torx screwdriver, trim removal tools, gloves and dielectric grease for electrical connectors. For best results inspect the rear lamp sealing surface and replace damaged seals or clips.
Why This Part Fails Most Often
- Impact Damage: Rear collisions or minor knocks commonly crack the lens or deform the housing.
- Moisture Ingress: Damaged or hardened seals allow water to enter, causing corrosion, short circuits or fogging of the lens.
- Electrical Issues: Corroded connectors, wiring wear or blown fuses can mimic lamp failure.
- Bulb/Module Failure: Conventional bulbs burn out over time; integrated LED modules can fail due to thermal stress or moisture.
- Vibration And Aging: Long-term vibration can loosen fixings and damage solder joints or connectors.
Practical Tips For Mechanics And DIYers
When replacing a lamp, check the connector pins for corrosion and apply dielectric grease to improve contact longevity. Verify the vehicle fuse and wiring if a newly fitted lamp does not illuminate. Keep the sealing surfaces clean and ensure clips and screws are tightened evenly to maintain a watertight fit. Use the product codes 6351J1 and 6351H2 when searching to quickly locate the correct part.
This replacement tail light offers a straightforward way to restore rear lighting functionality on Citroën Berlingo and Peugeot Partner models with a single rear door — suitable for professional fitment or competent DIY installation.
