Description
Left rear lamp for Peugeot 407 sedan up to 2008.
Overview
Direct-fit left rear lamp designed for Peugeot 407 sedan (up to 2008). Ideal for professional workshops and DIY enthusiasts who need a reliable replacement tail light assembly. Frequently searched under product codes 6350GC, 6350S8 and 6350V9 — include these references when locating the correct unit.
Features and Benefits
- OE-style housing and lens for correct fit and appearance.
- Restores full rear lighting function including brake, tail and indicator circuits (bulb type depends on vehicle equipment).
- Smooth installation into original mounting points — designed to match factory geometry and connectors.
- Durable lens material to resist road wear; replace when cracked, faded or leaking to preserve visibility and safety.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 407 Sedan (up to 2008)
- Product Codes: 6350GC, 6350S8, 6350V9
- Other Numbers: Not listed
Fitment And Compatibility
Fits left (driver-side in left-hand drive cars) rear body position of Peugeot 407 sedan models produced up to 2008. When searching or cross-referencing, use the product codes above. Check the lamp orientation and connector type against the vehicle before installation.
Installation Recommendations
Recommended for installation by experienced technicians or competent DIYers comfortable working with vehicle electrical and trim components. Typical replacement steps:
- Open the trunk and remove inner trim panel(s) to access the lamp mounting area.
- Unscrew or remove the retaining fasteners (nuts or clips) holding the lamp assembly.
- Carefully disconnect the wiring connector and remove the lamp from the body flange.
- Inspect wiring, bulb holders and sealing surfaces; transfer any bulbs or sockets if required by the supply type.
- Install the new lamp, secure fasteners to the correct seating, reconnect the wiring and test all light functions (tail, brake, indicator, reverse if applicable).
- Reinstall trunk trim and confirm correct alignment and sealing to prevent moisture ingress.
Use basic hand tools and a socket set. Replace damaged gaskets or sealing foam to maintain watertightness. After installation, verify that all lights operate correctly.
Common Causes Of Failure
- Impact Damage: Bumps or minor collisions commonly crack the lens or break mounting tabs.
- Water Ingress And Corrosion: Seal failure allows moisture into the lamp, causing corrosion of contacts and sockets or condensation that impairs light output.
- Socket And Connector Wear: Repeated bulb changes, vibration and corrosion can lead to poor contact or intermittent operation.
- Bulb Failure: Incandescent bulbs burn out over time; socket failure or wiring faults may mimic bulb issues.
Expected Service Life
There is no fixed replacement interval for the lamp assembly itself; service life depends on vehicle use and exposure. In normal conditions the housing can remain functional for many years, but replace it promptly if cracked, leaking or when electrical faults persist after bulb or socket inspection.
Notes
When searching for this part, include the product codes (6350GC, 6350S8, 6350V9) and the vehicle model (Peugeot 407) to improve match accuracy. Proper sealing and correct electrical connections are essential to avoid repeat failures.
