Description
Left rear lamp for PEUGEOT 206 3/5 doors
Until the year of production 6/2003
Side behind the driver
Part description
This left rear lamp Peugeot 206 is a used original car part designed for Peugeot 206 3/5 door cars. Thanks to the designation 6350P1, it is easy to find by product number, which will be appreciated by car repair shops and home mechanics when replacing a damaged rear light.
The part is suitable as a replacement for normal damage to the original lamp and represents a practical solution for repairing the car’s rear lighting. It is a part of the bodywork and lighting, which has a fundamental influence on the safety of traffic and the trouble-free use of the vehicle.
Technical information
Product codes
- Product codes: 6350P1
- Model names: Peugeot 206
Installation recommendations
Generally/typically for rear lamp replacement, the exact procedure may vary depending on the specific car design and mounting approach.
1) Before assembly
- Check if the left side, lamp shape, mount and connector match the old part.
- Compare the number 6350P1 and visually verify that the lamp corresponds to the design for the Peugeot 206 3/5 door.
- Inspect the condition of plastics, attachment points and sealing surfaces.
- If you are transferring parts from an old part, check their undamaged condition and clean contacts.
2) Necessary tools and materials
- A common set of hand tools
- Clean cloth
- Or a mild contact cleaner
- Work gloves
- Suitable lighting of the work area
3) Step-by-step assembly procedure
- Secure the vehicle against movement and switch off the ignition.
- Open access to the inside of the rear lamp.
- Disconnect the electrical connector of the original lamp carefully, without pulling on the wiring.
- Undo the fasteners of the old lamp and carefully remove the part.
- Check the contact surface of the bodywork and remove dirt that could prevent proper seating.
- Compare the new and original part side by side, especially the fit, shape and electrical connections.
- Set the lamp in place so that it fits properly and does not cross or strain anywhere.
- Install the fasteners and tighten evenly to avoid stressing the plastic.
- Connect the electrical connector and check that the connection is tight and free of play.
- Close access covers or trims if removed during disassembly.
-
4) Post-assembly checks and functional test verification
- Check the correct seating of the lamp against the body.
- Verify the function of the rear lighting according to the vehicle equipment.
- Make sure the lamp is firmly in place and does not show play.
- After a short run, visually check the fitment and connector again.
5) The most common assembly mistakes + how to avoid them
- Swapping left and right sides – always compare the shape and orientation of the part before assembly.
- Damage to the connector or wiring – never pull on the wires, only the connector.
- Uneven tightening – tighten gradually to avoid cracking plastic parts.
- Mounting on a dirty seating surface – clean the surface before placing the lamp.
- Overlooking cracks or damaged handles – always check the used part carefully before assembly.
Reasons why the part is damaged
- Damage from parking or minor impact from behind.
- Plastic cracking due to the age of the material and vibrations.
- Ingress of moisture and subsequent deterioration of the function of electrical contacts.
- Unsparing disassembly or assembly of the previous part.
- Normal wear and tear caused by operation and external influences.
