Description
Door handle for left rear and right front and rear doors for Citroën and Peugeot vehicles. Color EZR – Painted Aluminum Gray. We have various colors in stock.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën Berlingo III, Citroën C4 Picasso, Citroën Jumpy III; Peugeot 2008, Peugeot 207, Peugeot 308, Peugeot Partner III, Peugeot Expert III
- Product Codes: 9101GH, 9101.GH, EZRC 9101GH
- Other Numbers: EZRC
Product Overview
This exterior door handle is designed for the left rear and right front/right rear doors on a range of Citroën and Peugeot models. The part is painted in EZR Aluminum Gray finish and is supplied in the OEM-compatible color so it integrates with the vehicle exterior without further painting. It is a direct-fit replacement commonly sought under code 9101GH (or 9101.GH), making it easy to find and order for fast repairs.
Function And Fitment
The door handle provides the mechanical interface to open the door and works together with the internal linkage and latch assembly. It transfers the user motion to the latch mechanism and, if applicable, integrates with the door lock and central locking rods or cables. Correct fitment ensures smooth operation of the door release and proper alignment with the exterior bodywork.
Replacement Procedure
- Park the vehicle on level ground and secure it (handbrake on).
- Carefully remove the inner door card using plastic trim tools to avoid damaging clips and upholstery.
- Locate and disconnect the linkage rods or cables attached to the handle—note orientation for reinstall.
- Unscrew the fasteners securing the handle (usually accessible from inside the door). Keep bolts and clips for reuse if undamaged.
- Remove the old handle and transfer any required components (gaskets, trim rings, lock barrels) to the new handle if necessary.
- Install the new handle, secure fasteners to factory seating, reconnect linkage and door lock mechanisms, and check free movement before reassembling the door card.
- Test door opening/closing and central locking operation several times before finishing reassembly.
Installation Recommendations
- Use plastic trim tools to avoid breaking door-card clips and trim.
- Keep fasteners and clips organized; replace any worn or damaged clips during reassembly.
- Apply light grease to moving pivot points and metal-to-metal contact surfaces to ensure smooth action and reduce wear.
- Check lock cylinder alignment and central locking function before finalizing the door card fitment.
- If the door has electrical components (e.g., switches), ensure connectors are properly seated and protected from moisture.
Why This Part Most Commonly Fails
- Mechanical Wear: Repeated use causes internal plastic pawls, pivots or levers to crack or wear out over time.
- Impact Or Vandalism: External damage from impacts, attempted break-ins or rough handling can deform or break the handle.
- Corrosion And Environmental Exposure: Salt, moisture and road debris accelerate corrosion of metal fixings and can seize moving parts.
- Broken Clips Or Linkages: Plastic clips and rods that connect the handle to the latch are prone to snapping, resulting in a handle that moves but does not open the door.
- Paint And Finish Deterioration: Surface paint may chip or fade, prompting replacement for aesthetic or anti-corrosion reasons.
Practical Notes For Mechanics And DIYers
Part is often searched by its product codes (9101GH / 9101.GH / EZRC) — include these codes when ordering or checking fitment. Always inspect the entire door latch assembly and linkage when replacing a handle: a failing handle is often a symptom of worn linkages or a binding latch that should be serviced at the same time to avoid repeat repairs.
