Description
Socket with bulb for the right rear lamp of Peugeot 307 (3-door and 5-door). Functionality of the bulbs and their supply is not guaranteed. Supplied with a length of wiring.
This replacement tail lamp socket (bulb holder) is a practical solution for mechanics and DIY owners repairing the right rear light on Peugeot 307 models. The part provides a direct-fit mounting point for the rear bulbs and comes with a short section of wiring to simplify replacement of a damaged or corroded connector. Ideal for quick workshop repairs when the original socket is broken, burned, or the wiring is compromised.
Function And Description
The socket secures the bulb in the right rear lamp cluster and provides the electrical connection to the vehicle wiring harness. It ensures stable contact for brake, tail, and indicator bulbs. Over time sockets can suffer from corrosion, heat damage or weakened contacts that cause intermittent lighting or total failure.
Compatibility
- Peugeot 307 (3-door)
- Peugeot 307 (5-door)
- Fits 307 I and 307 II body variants where this socket type is used
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307
- Product Codes: 6351P3
- Additional Numbers: Not Available
Replacement Procedure
Recommended basic steps for a correct and safe replacement:
- Disconnect the battery before starting work to avoid short circuits.
- Remove the rear light cluster trim or access panel inside the boot to reach the lamp assembly.
- Unscrew or unclip the lamp cluster and withdraw it from the body, exposing the bulb holder.
- Unplug the old socket from the vehicle wiring harness and remove the bulb if necessary (note: bulb condition not guaranteed).
- Install the new socket: connect the wiring section, secure the holder in the lamp cluster and reinstall the cluster.
- Reconnect the battery and test all lighting functions (tail, brake, indicator). Replace bulbs with correct specification if needed and avoid touching halogen bulb glass with bare hands.
Installation Recommendations
- Wear gloves and use dielectric grease on contacts to reduce future corrosion.
- Check wiring for heat damage or brittle insulation and repair any compromised cables to prevent repeat failures.
- Use bulbs of the correct type and wattage specified for the lamp to prevent overheating of the socket.
Why The Part Fails Most Often
- Corrosion At Contacts: Moisture ingress causes poor contact and intermittent lighting.
- Overheating: Excessive bulb wattage or poor contact resistance can melt the socket.
- Mechanical Damage: Impact or rough removal/installation can crack the holder.
- Wiring Fatigue: Vibration and age can break wires or loosen connectors.
Keywords: Peugeot 307 tail light socket, rear lamp bulb holder, 6351P3, tail light wiring, replacement tail lamp socket.
