Description
Left rear lamp for Peugeot 307 hatchback from 2005. Bulb sockets not included.
Description
Direct-fit left rear tail light designed for Peugeot 307 hatchback models. This replacement lamp restores rear lighting functionality and exterior appearance after damage or wear. Ideal for professional mechanics and DIY enthusiasts who service Peugeot vehicles; often searched by product codes 557676 and 6350X0. The unit is supplied without bulb sockets, so verify bulb type and holders before installation.
Benefits & Use
High-visibility rear lamp ensures brake, tail and indicator lighting meet road safety requirements. Replacing a cracked or fogged lamp improves light output and prevents water ingress that can damage sockets and wiring. This part is suitable for collision repairs, bodywork restoration and routine replacement when seals or lenses are compromised.
How To Replace
- Park the vehicle on level ground, switch off ignition and engage the handbrake.
- Open the tailgate and remove the inner trim or access panel to reach the lamp retaining fasteners.
- Unscrew the retaining nuts or bolts that secure the lamp to the body (usually accessible from inside the boot).
- Carefully pull the lamp assembly outwards a few centimetres and disconnect the wiring connector.
- Remove the old lamp and check mounting tabs, gasket/seal condition and the wiring harness for corrosion.
- Fit the new lamp into position, reconnect the wiring, and temporarily test all rear light functions (tail, brake, indicator, reverse if applicable).
- Secure the lamp with original fasteners, re-fit interior trim and retest lights.
Note: This lamp Is Supplied Without Bulb Sockets. Ensure Correct Bulb Holders And Bulb Types Are Used; avoid touching bulb glass with bare hands.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 Hatchback (307 I and II)
- Product Codes: 557676, 6350X0, NFP
- Other Numbers: 6350X0
Installation Recommendations
Inspect Mounting Tabs And The Body Recess For Damage Before Fitting. Clean The Mating Surface And Replace The Rubber Gasket/Seal If Degraded To Prevent Moisture Entry. Use Dielectric Grease On Electrical Connectors To Reduce Corrosion. After Installation, Verify That All Rear Light Functions Operate Correctly And There Are No Error Messages On The Instrument Cluster.
Most Common Failure Reasons
Rear lamps Fail Most Often Due To Physical Damage (Impact From Minor Collisions), Cracked Lenses Allowing Water Ingress, Degraded Seals, Corroded Bulb Holders Or Wiring Connectors, And UV-Related Clouding Of The Lens. Heat Cycling And Vibration Can Also Loosen Mounting Tabs Over Time.
Why Choose This Replacement
Reliable replacement designed to match factory fitment dimensions and mounting points for a correct, durable installation. Using the correct product code (557676 / 6350X0) increases the chance of proper fitment and reduces installation time for professional workshops.
Order this left rear lamp to restore safety, compliance and the original look of your Peugeot 307 hatchback.
