Description
Motor for the left front window regulator for PEUGEOT 307 from 2005. Folding Mirror For The Vehicle, Driver’s Side. !!!!! Does Not Fit Convertible CC Model !!!!!
This replacement left front power window motor is designed for Peugeot 307 vehicles from 2005 and is intended for the driver side. It is a direct-fit unit commonly referenced by OE numbers and aftermarket codes listed below. The motor drives the window regulator mechanism, restoring smooth and reliable operation to the front left window. Suitable for professional workshops and experienced DIYers who maintain or repair Peugeot 307 power window systems.
Key Features
- Direct replacement for left front power window motor (Driver Side)
- OE Cross-References Included To Simplify Search And Ordering
- Designed For Vehicles Equipped With Folding Mirror On Driver Side
- Ideal For Mechanics And Skilled DIY Repairers
- Excludes Convertible CC Body Style
Compatibility
Compatible With: Peugeot 307 (from 2005) – Left Front (Driver Side). Not Compatible With: Peugeot 307 Convertible CC.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Peugeot 307 (Left Front Window Motor, Driver Side)
- Product Codes: 9681587480, 9649911380
- Additional Numbers: 9221S7, 9221CH
How The Part Is Replaced
General Replacement Procedure (For Experienced Technicians):
- Disconnect Battery: Always disconnect the vehicle battery before starting electrical component work.
- Remove Door Trim: Carefully remove the interior door panel to access the regulator and motor. Keep fasteners organized.
- Support Glass: Secure the window glass in the up position (use tape or a support) to prevent dropping during removal.
- Disconnect Electrical Connector: Unplug the motor electrical connector and any related wiring harness clips.
- Unbolt Motor From Regulator: Remove mounting bolts securing the motor to the regulator assembly and detach the motor.
- Install New Motor: Fit the replacement motor, tighten bolts to manufacturer torque where available, reconnect the electrical plug and test operation before reassembling the door panel.
- Final Check: Verify smooth travel of the window through full open/close cycles, check sealing and adjust regulator alignment if necessary, then reassemble the door trim.
Installation Recommendations
- Use Proper Tools: Torx and metric sockets are commonly required. Have trim tools to avoid damaging clips.
- Secure The Glass: Always support the glass when removing the regulator/motor to avoid breakage and injury.
- Clean And Lubricate: Clean regulator tracks and apply appropriate window-runner grease to reduce friction and extend component life.
- Check Wiring And Connectors: Inspect for corrosion or damaged pins and repair before fitting the new motor.
- Test Before Final Assembly: Cycle the window several times to ensure correct operation before refitting the door card.
Why This Part Fails Most Commonly
- Water Ingress And Corrosion: Moisture in the door can corrode motor brushes, gears, or connectors, causing failure.
- Worn Brushes Or Commutator: Over time the motor brushes wear, reducing performance until the motor stops moving the window.
- Mechanical Wear In Regulator: Excessive friction or damaged regulator components overload the motor and accelerate failure.
- Electrical Issues: Broken wires, poor grounds, or intermittent connectors can prevent the motor from receiving full power.
- Obstructions And Misalignment: Debris in the track or misaligned regulator causes high load on the motor and can burn it out.
Frequently Searched By Part Number: 9681587480 | 9649911380 | 9221S7 | 9221CH. If you regularly repair Peugeot 307 doors, having this motor in stock speeds up turnaround and restores passenger convenience quickly.
Buy Now To Replace The Faulty Left Front Window Motor And Return Your Peugeot 307 Window To Reliable Operation.
